Federal OSHA recorded a severe workplace injury
at MDR Construction, Inc., 1789 US-441 N, IRWINTON, GEORGIA 31042
on — Fractures , affecting the Ankle(s) and leg(s) unspecified.
Final narrative
Employees were working to unload a power line pole from a pole trailer and place it on the pole rack on the digger derrick truck. The injured employee hooked up pole tongs that were attached to the boom rope of the digger derrick to one of the poles on the trailer. As the digger derrick picked up the pole, it slipped out of the tongs and landed on the leg/ankle of the injured employee resulting in a broken left leg and ankle.
Hospitalized Ankle(s) and leg(s) unspecified Utility poles
An employee was picking up an outrigger pad when his right arm became caught between the moving outrigger and the outrigger housing. The employee sustained swelling in his lower right arm. He was hospitalized.
A lineman was on a power pole holding a jumper wire. The wire contacted an energized primary line; the resulting arc flash caused first-degree burns to the lineman's face and second-degree burns to the lineman's right arm.
An employee was constructing a new electrical distribution line. While connecting a neutral line near an energized primary phase, the employee's face contacted the energized phase resulting in burns to his face and arm. The employee was hospitalized.
An employee was working inside a bucket truck replacing old power lines with new power lines. An arc occurred between the two lines and one employee was burned on his stomach and left arm.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.
An employee was attempting to lift a steel beam from a horizontal, stacked position to a vertical position using a crane. They had placed two hooks on the east side of the beam on the flange. As the employee was hoisting the crane, the beam began to shift and pulled the employee forward onto the stack. When the material shifted, the hooks released and the material fell, pinning the employee between the two beams. The employee was hospitalized with soft tissue contusions on their proximal right thigh and interior left thigh.
An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.
An employee was troubleshooting the control setup for a variable air volume box above a ceiling. The employee's hand came into contact with an exposed, energized 277-volt wire that had loosened from its terminal on the box's assembly. He was shocked and fell off a ladder. His left hand passed across the ceiling grid and was lacerated. He also suffered an electrical burn to the right hand and was hospitalized.
An employee was moving a scissor lift through a doorway. The employee was pinned between the scissor lift and the doorframe, sustained a back injury, and was hospitalized.
An employee was standing on an A-frame ladder approximately 6 feet above the floor while he attached a suspended light fixture to the ceiling. The employee lost balance, and fell to the tiled floor below, sustaining blunt force trauma to his head.
An employee was inspecting the overhead area of a single-person lift and repositioning the lift through a double doorway. As they were transitioning through the doorway, they were caught between the doorframe and the vertical mast of the lift. The employee was hospitalized with injuries to the nose, left maxillary sinus, left orbital bone, and left jaw, with fractures at the maxillary sinus area.
The injured employee was performing routine maintenance on a fan belt/pulley. The injured employee and another person were moving the pulley back and forth manually to find a bearing issue. The injured employee's left ring finger got caught between the belt and the pulley wheel, resulting in a soft tissue amputation.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.