Direct exposure to electricity, greater than 220 volts · Electrical burns, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at MDR Construction, Inc., Beelino Road, BEGGS, OKLAHOMA 74421
on — Electrical burns, unspecified, affecting the multiple body parts, n.e.c..
Final narrative
An employee was constructing a new electrical distribution line. While connecting a neutral line near an energized primary phase, the employee's face contacted the energized phase resulting in burns to his face and arm. The employee was hospitalized.
HospitalizedMultiple body parts, n.e.c.Power lines, transformers, convertors
Employees were working to unload a power line pole from a pole trailer and place it on the pole rack on the digger derrick truck. The injured employee hooked up pole tongs that were attached to the boom rope of the digger derrick to one of the poles on the trailer. As the digger derrick picked up the pole, it slipped out of the tongs and landed on the leg/ankle of the injured employee resulting in a broken left leg and ankle.
An employee was picking up an outrigger pad when his right arm became caught between the moving outrigger and the outrigger housing. The employee sustained swelling in his lower right arm. He was hospitalized.
A lineman was on a power pole holding a jumper wire. The wire contacted an energized primary line; the resulting arc flash caused first-degree burns to the lineman's face and second-degree burns to the lineman's right arm.
An employee was working inside a bucket truck replacing old power lines with new power lines. An arc occurred between the two lines and one employee was burned on his stomach and left arm.
An employee was installing a ground wire to a power transmission pole. The ground wire contacted an energized portion of a cut-out, causing an arc-flash. The employee was hospitalized with second degree burns to their chest and arms.
An employee was connecting a utility transformer for underground service to a home. The employee's impact drill went across two connection bars with 240 volts of potential, creating an arc flash. The employee sustained burns to the face and eyes due to the arc flash and molten aluminum.
On December 15, 2023, at 9:15 AM, an employee was changing 60-amp fuses in a 480-volt panel when an arc flash occurred. The employee was hospitalized with burns to both hands.
An employee was terminating cables in a junction box. A loose ground wire came into contact with the bushing, causing a flash that burned the right side of the employee's face and his right hand.
An employee was using a bucket truck hoist to raise secondary aerial wiring. The wire made contact with the primary wire, causing an arc flash. The employee suffered burns to both hands and was hospitalized.
An employee was terminating conductors to buss bars inside the secondary compartment of a single-phase transformer. An arc flash occurred, causing burns to the soft tissue of the employee's face.
An employee was securing the claw of a grapple truck to the truck bed. His left little finger was caught between the tie down strap and the rub rail of the truck, resulting in partial amputation of the finger.
An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.
An employee was working in the food service warehouse when he experienced chest pain, difficulty breathing, and lost consciousness. The employee sustained carbon monoxide poisoning.
An employee was cutting a piece of metal rod with a metal cutting machine. His right middle finger became caught between the rod and the machine's table. The employee's fingertip was partially amputated.
An employee was working at her desk. She went to stand up and fell to the floor beside the desk. The employee sustained a hip displacement and required surgery.
An employee was processing wood boards at a chop saw when the saw malfunctioned and the blade cut her left hand and fingers. She was hospitalized and her little finger was surgically amputated.