Cambridge Pavers, Inc.

An employee was switching out a cylinder on a conveyor belt. The cylinder shifted and the employee's left hand was caught between the seal and the cylinder, resulting in an open fracture of the hand. The employee was hospitalized.

An employee was cutting a board using a circular saw. The saw pinched, kicked back, and cut the employee's left ring and little fingers. The employee suffered an amputation to the little finger.

An employee was cutting wood with a circular saw. The saw kicked back, and its blade cut three fingers on the employee's right hand, resulting in an amputation.

An employee was using a table saw to cut wedges for a deck when the wood jumped and his right palm was lacerated by the blade.

An employee was doing a cutback on a piece of lumber using a chop saw. The saw hit a knot, the piece of lumber buckled, then kicked back and broke the kickback guard. The board was then pulled back into the blade, which lacerated the employee's left index and middle fingers.

An employee was cutting wood with a circular saw. The machine lagged and cut the employee's finger. The employee required surgical amputation of the finger at the hospital.

An employee was shoveling excess material (spillage) that consisted of dry mix, sand, aggregate and cement. As he was shoveling, some material blew back in his face and around his safety glasses. He got a piece of metal in his left eye that required surgery. The employee was hospitalized.

An employee was spotting the dust auger as it was lowered onto the trailer so that it would not contact a piece of equipment already on the trailer and pinch electrical cords. As the auger was being moved into place horizontally, his thumb was caught between two brackets, one on the auger and one on a piece of equipment already on the trailer. The employee sustained a partial amputation to the left thumb.

A temporary employee was bending rebar on a bending table (machine) when his right little finger got caught in the rollers. The employee sustained an amputation down to the first knuckle below the fingernail.

At 10:00 a.m., an employee was preparing to cut lumber for an A-frame structure using a compound miter saw when the saw kicked back and contacted his left hand. The employee sustained complete amputation of the thumb and a partial amputation of the index finger.

An employee was unloading a bundle of quartz slabs from a truck bed using a forklift and lifting slings. The employee was standing on the truck bed to secure the slings to the bundle when one of the two A-frames supporting the bundle fell over. The employee jumped off the truck bed to avoid being hit, causing them to strike the ground and sustain fractures to their left hip, femur, and elbow.

An employee tripped over a stool and fell on the floor, resulting in a left displaced mid-cervical femoral neck fracture.

An employee was installing fence posts when they stepped into a recently dug hole that was not visible due to rainfall. The employee's leg was fractured.

An employee assisted in cleaning material from a conveyor pit. After the pit was cleaned, the employee proceeded to replace metal safety plates to ensure other employees did not fall into the pit. While replacing one of the last plates, the employee mis-stepped and fell approximately 5 feet into the pit. The employee was hospitalized with back/side bruising, elbow bruising, bone bruises, and/or fractured ribs.

An employee was inspecting a breaker box and turning on/off a circuit breaker when he was electrocuted.

An employee was walking on the sidewalk. When they stepped off the curb, they fell to the ground, resulting in fractures to their tibia, fibula, and a metatarsal.