Turnagain Marine Construction Corporation

An employee was assisting with pre-welding setup on pile structures at the fuel dock worksite. They were working to operate a come-along to align a waler to the pile. Due to limited leverage and restricted positioning within the man basket of the crane, the employee exited the basket to manually adjust the waler from the structure itself. During the task, wave height and frequency increased. A large wave struck the area, causing the pile braces and walers to shift. The employee lost their footing and grabbed the production pile edge. Their fingers on one hand were crushed between two structural steel piles. The employee sustained an amputation to the fingers and was hospitalized.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

A service crew was pulling a pump and motor from a well. After breaking a joint of pipe loose from another joint, an employee grabbed the chain tongs to prevent the pipe from spinning in the well, so the crew could continue taking it apart. The bolt that attaches the chain to the handle of the chain tongs broke, causing the chain to swing around and strike the employee's lower right leg. The chain severely punctured his leg and fractured his tibia.

An employee was using a handheld grinder to cut a bolt. The grinding wheel broke apart and a fragment struck the employee s right hand, causing a laceration to the palm near the little finger.

An employee was operating a brake press when the top die broke, causing the bottom die to roll out and onto the employee's legs. Both of the employee's legs were crushed below the knee, and both legs were partially amputated. The employee's left leg was also fractured above the knee.

A pressurized aircraft nose landing gear strut assembly was being disassembled. The gland nut dislodged under pressure and made contact with an employee's left hand, breaking it.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.

Employees were securing the fuel line of an outboard motor in preparation for removing the motor from a small vessel located in the equipment yard. A gasoline-related fire occurred and one employee sustained burns to both hands and forearms.

A marine diver/construction worker was working underwater, using a hydraulic dredge to clear sediment away from the base of a dam. The dredge's suction nozzle began migrating toward him, and then pulled in his right hand and forearm. He sustained compartment syndrome in the hand and forearm.

An employee was standing on a sheet of -inch by 4-foot by 8-foot plywood on top of a rebar mat, supervising his crew. As he was moving to alert the crew to an incoming overhead load, he stepped off the plywood and his left foot slipped through the rebar mat and landed on the rebar mat below. His left ankle was broken and dislocated.

An employee was assisting with pre-welding setup on pile structures at the fuel dock worksite. They were working to operate a come-along to align a waler to the pile. Due to limited leverage and restricted positioning within the man basket of the crane, the employee exited the basket to manually adjust the waler from the structure itself. During the task, wave height and frequency increased. A large wave struck the area, causing the pile braces and walers to shift. The employee lost their footing and grabbed the production pile edge. Their fingers on one hand were crushed between two structural steel piles. The employee sustained an amputation to the fingers and was hospitalized.

An employee was lifting a manhole cover when it fell on his right foot, resulting in the amputation of his big toe and the adjacent toe.

An employee was in a tunnel freezer, which was being turned on for the first time. The baffling for the evaporator fan got stuck in the siding. The employee ascended a 5'9"-tall cart to reach the raised baffling panel. The raised baffling shifted and dropped, trapping the employee's arm between the aluminum and foam core baffling. The employee sustained a severe laceration to the lower forearm/upper wrist and severed ligaments. The employee was hospitalized.

An employee was engaging in daily physical training in preparation for fire season as a smokejumper. The employee sustained swelling and stiffness in their arms and was hospitalized with rhabdomyolysis.

An employee was training and running and suffered rhabdomyolysis.