Federal OSHA recorded a severe workplace injury
at Horton, Inc., 10840 423rd Avenue, BRITTON, SOUTH DAKOTA 57430
on — Disc disorders, herniated disc, affecting the Exterior and musculoskeletal structures of the back unspecified.
Final narrative
An employee was using a swing-reach forklift to retrieve wooden pallets loaded with product, which were approximately 12 feet from the floor. The forklift abruptly stopped, the load dropped onto the pallet rack platform, and the forklift dropped down to floor level. The product, which was still suspended by the forks and the pallet rack platform, began to spill out of the container. The employee felt back pain and tingling in his fingers. He was hospitalized overnight and treated for a herniated disc.
Hospitalized Exterior and musculoskeletal structures of the back unspecified Forklift, order picker, platform truck powered
An employee was operating an agricultural tractor during sugarcane harvesting. The employee sustained a lumbar sprain due to vibration or motion from the tractor.
An employee was operating a compact open-cab skid steer. As he backed up, the skid steer's bucket lowered onto his leg, pinning it against the body of the skid steer. He was hospitalized, requiring surgery to the ankle/lower leg.
An employee was backing up a garbage truck at a landfill to empty the truck. A concrete platform gave way, causing the vehicle to slide down into the landfill pit 20 feet below. The employee was flung backward and forward, hitting his head on the dashboard of the vehicle. The employee was hospitalized with a concussion.
An employee was operating a rubber-tracked crawler carrier to offload and place timber mats that are used for vehicular and equipment access on a utility right-of-way. The offloading of the mats from the dump bed caused the front end of the equipment to elevate and then come back down with force. The employee sustained compression fractures to two vertebrae in their lower back and was hospitalized.
An employee was moving a hoist to the end of a bridge rail to create space for another hoist on the same rail. The hoist being moved, along with its supporting beam, detached from the bridge rail and fell, striking the employee in the head. He suffered a contusion and laceration to the head and was hospitalized.
An employee was operating a machine. When they performed a motion to push a machined engine block away from their body, they experienced a back strain, resulting in hospitalization.
On September 13, 2025, an employee had been working at an outdoor event. At the end the day, she was walking around outside the facility to make sure everything was put away and felt overheated. The employee was hospitalized for heat-related illness.
An employee was installing insulation in a wall panel when the panel fell on top of them, resulting in leg and back injuries that required hospitalization.
An employee put a cylinder machining pallet into manual mode to unjam it. After completing the task, their left hand became lodged between a pulley and belt, resulting in the amputation of three fingers.
An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.
An employee was walking past a crossover conveyor when a ramp came down and hit them in the back. The employee sustained a broken back vertebra, as well as a concussion, and was hospitalized.
An employee was using a hook tool to pull a pallet onto the lift gate of a tractor trailer. The hook detached from the underside of the pallet, causing the employee to fall backward off the lift gate. The employee landed on the concrete parking lot about 5 feet below, suffering fractures to the skull and two thoracic vertebrae.
An employee was walking on a truss table when he lost his balance and fell approximately 3 feet to the floor. The employee sustained a dislocated and fractured left ankle.