105,313Records 71,083Employers 85,290Hospitalizations 27,770Amputations 2015-01-01 2025-10-31
Safety Incidents OSHA Severe Injury Reports · 2015–2025

Tully Construction Co., Inc.

Struck by dislodged or detached object(s) · Fractures

Federal OSHA recorded a severe workplace injury at Tully Construction Co., Inc., Van Wyck Expressway, Nassau Expressway, BRIARWOOD, NEW YORK 11435 on — Fractures , affecting the Hand(s), finger(s) unspecified.

An employee was lowering a scaffold beam with a hand crank when the chain fall failed and the scaffold beam struck them. The employee sustained fractures to their right ankle and left hand.

Hospitalized Hand(s), finger(s) unspecified Scaffolds, staging unspecified

Tully Construction Co., Inc.

An employee was walking on the service road when they were struck by a drill rig counterweight. The employee was hospitalized with a fractured pelvis.

Tully Construction Co., Inc.

An employee stepped on pipe scaffolding bracing and the bracing failed, causing them to fall and suffer a broken ankle.

Tully Construction Co., Inc.

An employee was unloading material to back fill the 36-inch sewer main when concrete debris caused the rear door on the dump trailer to get wedged open. The employee lifted the door to free the concrete debris. Once the debris was free it suddenly closed, causing the employee's right ring finger to get pinched between the door and the body of the truck. The employee sustained a laceration and fractured finger on the right hand.

View Tully Construction Co., Inc.'s full OSHA safety record →

NATIONAL MILL MAINTENANCE, LLC

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

C. Miller Drilling Inc

A service crew was pulling a pump and motor from a well. After breaking a joint of pipe loose from another joint, an employee grabbed the chain tongs to prevent the pipe from spinning in the well, so the crew could continue taking it apart. The bolt that attaches the chain to the handle of the chain tongs broke, causing the chain to swing around and strike the employee's lower right leg. The chain severely punctured his leg and fractured his tibia.

Rolling Frito-Lay Sales, LP

An employee was using a handheld grinder to cut a bolt. The grinding wheel broke apart and a fragment struck the employee s right hand, causing a laceration to the palm near the little finger.

Blackburn's Fabrication, Inc.

An employee was operating a brake press when the top die broke, causing the bottom die to roll out and onto the employee's legs. Both of the employee's legs were crushed below the knee, and both legs were partially amputated. The employee's left leg was also fractured above the knee.

Textron Aviation Inc. (Orlando Service Center)

A pressurized aircraft nose landing gear strut assembly was being disassembled. The gland nut dislodged under pressure and made contact with an employee's left hand, breaking it.

Cashless Tolling Constructors

An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.

Anderson Columbia Co., Inc.

An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.

FLATIRON CONSTRUCTION CORP.

A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.

Warner Brothers, LLC

An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.

Don Martin Corporation

An employee was working with paving equipment and heard a noise on the opposite side of the machine he was working on. When the machine stopped, the employee went to the opposite side and crouched down to investigate the noise. A mini track loader backed up and drove over the employee's leg. The employee sustained fractures to their lower leg, ankle, and foot.

Garden Angels New York LLC

An employee was cleaning leaves with a backpack blower when he fell from a ladder, resulting in injuries to his head, neck, and back.

Cashless Tolling Constructors

An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.

NYU Langone Hospital-Brooklyn

An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.

VILLAGER CONSTRUCTION, INC.

An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.