Contact incidents unspecified · Amputations involving bone loss
At a glance
Federal OSHA recorded a severe workplace injury
at Diamond Plastics Corporation, 2323 Marshall Street, LUBBOCK, TEXAS 79415
on — Amputations involving bone loss, affecting the Other finger(s) n.e.c..
Final narrative
At about 2:50 a.m. on January 8, 2024, an employee was changing some tooling when the top of the tooling came down and caught his left index and middle fingers. The index finger was lacerated and broken. The middle finger was medically amputated above the first knuckle.
Amputation Other finger(s) n.e.c. Machinery unspecified
More severe injuries at Diamond Plastics Corporation
An employee was changing the water filter on an extruder. The lid, which was hanging from a hook, came loose and fell onto his hand. His right middle finger was amputated.
An employee was operating forklift to raise and move a pump into a building when the pump began to swing. The employee asked a coworker to stabilize the swinging pump. When he touched it, he stated he received a shock. The employee then exited the forklift and touched the pump, receiving a severe electrical shock.
A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.
An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.
An employee had been cleaning the work area. While lifting a saw, the employee's index finger was lacerated by the saw blade. A tendon was cut and required surgery.
An employee was installing a hydraulic extension cylinder in a tow truck when their leg was caught between the cylinder and the truck frame. The employee was hospitalized with a broken tibia, which required surgery.
An employee was sorting sucker rods. His right hand was caught in the area where the rod hits up against the frame and his index fingertip was amputated just below the nail.
More severe injuries in this industry (NAICS 326122)
Employees were hooking up a new reel of pipe to be processed into shorter lengths. This process involved routing a winch cable through a haul-off and attaching it to the pipe using a clamp. One employee held the winch cable while another pressed the feed-out button to loosen the cable. The cable tightened and pulled the hand of the employee holding it into a pulley. The employee's right index and middle fingertips were amputated at the first knuckle.
On 8/22/2025, an employee was working to clear a grinder jam. The employee was using a "no-touch tool" to rotate the drum of the grinder. He slipped forward and his right hand contacted a pinch point between the backside of the blade and the grinder housing. The employee's right middle fingertip was partially amputated with bone loss.
At about 1:25 a.m. on August 14, 2025, an employee was operating a 10-inch band saw at a molding machine. The employee was working to cut the sprue off a PVC fitting. The blade snagged on the sprue and pulled his left index finger into the blade, which cut it. The finger was partially medically amputated.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.