Struck by dislodged or detached object(s) · Fractures and soft tissue injuries
At a glance
Federal OSHA recorded a severe workplace injury
at Scout Energy Management, LLC., 11432 E Road 3, ULYSSES, KANSAS 67880
on — Fractures and soft tissue injuries, affecting the Wrist(s) and elbow(s).
Final narrative
An employee was removing an inboard discharge valve on an inlet cylinder. The pressure caused the compressor valve cap and valve to come out of the cylinder and strike the employee, resulting in a fractured wrist, dislocated elbow, and a torn ligament.
Hospitalized Wrist(s) and elbow(s) Valves, nozzles
More severe injuries at Scout Energy Management, LLC.
An employee was standing at the base of a work-over rig that was being scoped down. He was holding the guide cables, standing near the base of the rig, and looking up as it was lowered. A 3-inch snatch block fell from the pole platform (about 21 feet up) and struck the employee in the face. The employee suffered a broken nose and was hospitalized.
On July 17, 2925, an employee was working on a computer inside a vehicle when they began experiencing symptoms of carbon monoxide poisoning, resulting in hospitalization.
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
A service crew was pulling a pump and motor from a well. After breaking a joint of pipe loose from another joint, an employee grabbed the chain tongs to prevent the pipe from spinning in the well, so the crew could continue taking it apart. The bolt that attaches the chain to the handle of the chain tongs broke, causing the chain to swing around and strike the employee's lower right leg. The chain severely punctured his leg and fractured his tibia.
An employee was using a handheld grinder to cut a bolt. The grinding wheel broke apart and a fragment struck the employee s right hand, causing a laceration to the palm near the little finger.
An employee was operating a brake press when the top die broke, causing the bottom die to roll out and onto the employee's legs. Both of the employee's legs were crushed below the knee, and both legs were partially amputated. The employee's left leg was also fractured above the knee.
A pressurized aircraft nose landing gear strut assembly was being disassembled. The gland nut dislodged under pressure and made contact with an employee's left hand, breaking it.
More severe injuries in this industry (NAICS 211120)
An employee was standing in an excavation, about 12 feet deep, to check a natural gas pipeline for leaks. The excavation's sides sloughed, and the employee was buried up to the waist. The employee suffered a broken left lower leg.
An employee was working to close a gate that had gotten stuck. He was pushing on the top rail when it started moving and his left little finger became crushed between the rollers and the top rail, resulting in an amputation below the bottom knuckle.
An employee was performing winching operations on a flatbed when their left hand was pinched between a winch hook and a nylon bridle resulting in the amputation of his left index finger.
An employee was inspecting the facility. There was a frozen injection line. The employee was going to put methanol in the line to thaw it out. He isolated the line to pour in the methanol and was bleeding off the gas inside the isolated line. He opened up the needle valve. A flash fire occurred. He reached up to shut the needle valve and sustained burns to his left ear, face, and left hand. The employee was hospitalized.
At 12:00 p.m. on March 14, 2025, an employee was operating a valve when it broke. This caused him to lose his balance and fall backward. He landed on a strip of metal and his right index finger was pinched between the metal and his leg. The weight of his leg and the impact from falling caused the amputation of his fingertip.
An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.
An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.
An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.