Fall on same level due to slip or trip · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Hammond Lumber Company, 1513 Maine 102, BAR HARBOR, MAINE 04609
on — Fractures , affecting the Skull.
Final narrative
An employee was unlocking the main gate to prepare for sanding and plowing. He slipped on a patch of black ice on the driveway, fell, and hit his head, resulting in a skull fracture.
An employee was strapping down a load of lumber onto a flatbed truck. While attempting to get down from the back of the flatbed, he fell 3.5 to 4 feet and hit the ground. He was hospitalized with a collapsed lung.
An employee was installing fence posts when they stepped into a recently dug hole that was not visible due to rainfall. The employee's leg was fractured.
The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.
An employee was walking down the off ramp from a box truck, carrying a door for delivery. A strong wind caught the door, causing the employee to lose balance and fall about 2 to 3 feet to the ground. He landed on his back and suffered a broken vertebra.
An employee was delivering lumber to a customer's job site. He was using a truck-mounted forklift to transport the material to the staging area. The surface of the path of travel changed from asphalt to soil and rock with a slight downward grade. When the forklift moved onto the softer surface, it sank into the ground and its center of gravity shifted forward, causing it to tip over. The employee's right arm sustained a closed, supracondylar humerus fracture.
An employee was helping two forklift operators move and inventory flat sheet metal that was staged on racks. The metal fell off one side and struck the employee's arms and abdomen. The employee sustained a laceration above the left eye, a left forearm injury, and a ruptured spleen. The employee was hospitalized and required surgery.
A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.
Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.
An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.
An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.