105,313Records 71,083Employers 85,290Hospitalizations 27,770Amputations 2015-01-01 2025-10-31
Safety Incidents OSHA Severe Injury Reports · 2015–2025

Island Mechanical Corporation

Struck by other falling object n.e.c. · Traumatic injuries or exposures unspecified

Federal OSHA recorded a severe workplace injury at Island Mechanical Corporation, Road in Piti, PITI, GUAM 96915 on — Traumatic injuries or exposures unspecified, affecting the Leg(s) unspecified.

An excavator bucket fell, bounced, and struck an employee's leg, injuring it. The employee was hospitalized.

Hospitalized Leg(s) unspecified Vehicle and machine front attachments

RG Professional Carpenter, Inc.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

Rae Corporation

An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.

Red Dot Corporation

An employee was attempting to lift a steel beam from a horizontal, stacked position to a vertical position using a crane. They had placed two hooks on the east side of the beam on the flange. As the employee was hoisting the crane, the beam began to shift and pulled the employee forward onto the stack. When the material shifted, the hooks released and the material fell, pinning the employee between the two beams. The employee was hospitalized with soft tissue contusions on their proximal right thigh and interior left thigh.

Simon Contractors of South Dakota, Inc.

An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.

RJV Construction

An employee was rigging I-beams. An I-beam slid off the stack of I-beams and fractured the employee's leg.

HB Fleming, Inc.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Takkion OPS Management

An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.

Ahtna Marine and Construction Company, LLC

Employees were securing the fuel line of an outboard motor in preparation for removing the motor from a small vessel located in the equipment yard. A gasoline-related fire occurred and one employee sustained burns to both hands and forearms.

Michels Construction, Inc

A marine diver/construction worker was working underwater, using a hydraulic dredge to clear sediment away from the base of a dam. The dredge's suction nozzle began migrating toward him, and then pulled in his right hand and forearm. He sustained compartment syndrome in the hand and forearm.

Bechtel Energy Construction Services, Inc.

An employee was standing on a sheet of -inch by 4-foot by 8-foot plywood on top of a rebar mat, supervising his crew. As he was moving to alert the crew to an incoming overhead load, he stepped off the plywood and his left foot slipped through the rebar mat and landed on the rebar mat below. His left ankle was broken and dislocated.

Samsung E&C America, Inc.

An employee was moving a ramming machine to a staging area. While using the controls on the side of the machine, there was a sudden heavy rainfall causing the equipment to slide. The ramming machine tipped over and caught the employee against the ground. The employee sustained a fracture to the right side of their pelvis and was hospitalized.

Orion Construction Corporation Guam

During prep work and installation of formworks, a metal plate slid and caught an employee's left thumb. The employee suffered an open fracture to the last joint of the thumb and required surgery. The employee was hospitalized.

Dept. of Defense - USA

At 10:20 a.m. on August 11, 2025, an employee slipped on a damp sidewalk covered with a thin layer of algae. The employee suffered multiple fractures to the left femur and was hospitalized, requiring surgery.

Catalyst Construction

An employee was bending rebar when their glove became caught and their right index finger was amputated in the rebar bending machine.

Baker International Inc.

An employee was inflating a new tire on a tug. The tire exploded, lacerating the employee's right hand and breaking their right hip.