Caught, entangled in running powered equipment normal operation · Nonfatal 'crushing' injuries
At a glance
Federal OSHA recorded a severe workplace injury
at Quality Metals, Inc., 6460 Langfield Rd., HOUSTON, TEXAS 77092
on — Nonfatal 'crushing' injuries, affecting the Arm(s) unspecified.
Final narrative
An employee was using a machine to put corrugation bends in flat sheet metal. The employee was feeding a new roll of sheet metal into the machine when his glove got caught by the first series of rollers and an adjacent chain and sprocket. The rollers crushed the employee's arm which required surgery and hospitalization.
On August 26, 2021, an employee was working from an aerial lift basket, installing metal wall panels on a new building. He fell out of the basket, landed 10 feet below on a lower canopy roof, then bounced/rolled off and fell 15 feet to the dirt ground. He suffered a broken wrist, broken ribs, a ruptured spleen, and a punctured lung and was hospitalized.
On March 10, 2021, an employee was using a 12-foot A-frame ladder to pull insulation panels off a shelf when he lost his balance and fell 6 to 7 feet to the concrete floor, resulting in a fracture to his left ankle that required hospitalization.
An employee was operating a metal roller machine to roll a small piece of metal. The employee's right index finger became caught between the metal and the machine, and the fingertip was amputated.
An employee was working on a production line. The employee went to retrieve parts that came out of the parts holder, and their left hand became caught between a chain and a sprocket. Three fingers on the hand were amputated.
An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.
An employee was operating a pad printer. The employee's finger was caught in the printer and they suffered a fingertip amputation. The part of the printer that caught the employee's finger was unguarded at the time.
More severe injuries in this industry (NAICS 332311)
An employee was cutting a piece of metal rod with a metal cutting machine. His right middle finger became caught between the rod and the machine's table. The employee's fingertip was partially amputated.
Two maintenance employees were dismantling a machine part (steel cylindrical rollers) on the ground. After unbolting a portion, part of the assembly fell approximately 6 inches onto one employee's left little finger. The employee was hospitalized and about 3/4" of their little finger above the top joint was surgically amputated.
An employee was moving and handling cardboard boxes when he sustained a laceration to his left ring finger from a box. The laceration became infected and required hospitalization and surgery.
An employee was positioning a piece of metal trim for a test bend in a single-fold bend machine. Their right middle fingertip was pinched by a clamp on the machine, resulting in a partial amputation.
An employee was operating a double folding machine and positioning a piece of metal trim in the folding clamps for a test bend. The machine activated and the crank (lower control arm that bends the trim) came up and cut through the employee s glove, amputating their right middle fingertip.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.