Exposure to electric arc · Electrical burns any degree
At a glance
Federal OSHA recorded a severe workplace injury
at Bri-Steel Manufacturing, 2215 S. Van Buren St, ENID, OKLAHOMA 73703
on — Electrical burns any degree , affecting the Head and extremities.
Final narrative
An employee was working on a electrical panel when his flashlight contacted the panel, creating an arc flash. He suffered second- and third-degree electrical burns to his arms and parts of his face.
Hospitalized Head and extremities Switchboards, panels, fuses
An employee was terminating cables in a junction box. A loose ground wire came into contact with the bushing, causing a flash that burned the right side of the employee's face and his right hand.
An employee was using a bucket truck hoist to raise secondary aerial wiring. The wire made contact with the primary wire, causing an arc flash. The employee suffered burns to both hands and was hospitalized.
A temporary employee was testing an electrical starter motor. He was placing tape on the starter while the breaker was not engaged, but the starter sent an arc flash that burned his hands and stomach.
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
An employee was cutting wooden boards using a table saw when the glove on his left hand was caught by the blade, resulting in a partial fingertip amputation.
An employee was placing a board on top of a bundle of steel tubing. A crane was moving a bundle of steel that struck the employee and caught them against another bundle of steel tubing. The employee sustained a crushing injury and hematoma to the right upper leg.
A crane was hoisting a pipe. An employee was adjusting twisted lifting chains on the end of the pipe when the pipe was raised, causing the employee's hands to be caught between the chains and the pipe. The employee suffered injuries to the left index finger, left ring finger, right ring finger, and right index finger; the right index fingertip was amputated without bone loss.
During a routine inspection, an employee placed their hand on a pipe to check a weld. The pipe clamp activated, closed on the pipe, and trapped the employee's right middle finger, resulting in a partial amputation and fracture to the fingertip as well as a laceration to the ring finger.
An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.
An employee was working in the food service warehouse when he experienced chest pain, difficulty breathing, and lost consciousness. The employee sustained carbon monoxide poisoning.
An employee was cutting a piece of metal rod with a metal cutting machine. His right middle finger became caught between the rod and the machine's table. The employee's fingertip was partially amputated.
An employee was working at her desk. She went to stand up and fell to the floor beside the desk. The employee sustained a hip displacement and required surgery.
An employee was processing wood boards at a chop saw when the saw malfunctioned and the blade cut her left hand and fingers. She was hospitalized and her little finger was surgically amputated.