Dept. of Defense - USN

An employee was working on an electrical panel in a mechanical room when an arc flash occurred. The employee suffered burns.

An employee was preparing a barge for the end of a day's drilling operations. He was setting a spud on the barge when the spud struck him and broke his right leg.

A team of employees was moving boats from one slip in a marina to another using rope. An employee slipped while moving around in a boat and suffered a broken left femur.

The injured employee was standing by the controls for the electric spud system on the barge, preparing to raise the spuds. Meanwhile, an excavator was moving a mat on the deck. As the excavator swung from port to starboard, it's counterweight struck the injured employee s shoulder, causing them to lose balance and fall against the spud controls. The employee sustained bruises and contusions to their right shoulder and chest.

An employee was inserting dogbone links (4 feet 9 inches in length) into the slots between sectional barges to connect the barges. A dogbone link became stuck in the slot and needed to slide down approximately 1 foot to be seated. The employee went to lift the dogbone link up and adjust it when the link became free. A burr on the flange of the link snagged the employee's right glove. The link slid into a seated position and the employee's right middle finger was caught between the top surface of the barge and the top flange of the dogbone link. The finger was partially amputated at the midsection of the distal phalanx.

An employee was working to unload cargo from a ship. A steel coil contacted the employee's left leg. The lower leg was fractured.

An employee was activating the sprinkler system at a sports complex following recent maintenance to repair leaky pumps. When the system was activated, a section of newly installed 3-inch schedule 80 PVC pipe struck the employee, who lost consciousness. The employee suffered a broken jaw and a concussion.

An employee was ascending a flight of stairs after exiting their vehicle in an adjacent employee parking lot. The employee stepped to the right to avoid another employee on the left who was descending the stairs. The employee lost their balance and fell on the stairs. They were hospitalized with a laceration/abrasion to their chin, a fractured left humerus, and bruising to their left knee.

An employee was working on an electrical panel in a mechanical room when an arc flash occurred. The employee suffered burns.

At about 3:10 p.m. on October 3, 2025, an employee was inspecting a car. Two dogs that had been in another car were leashed and tethered to a bollard. As the employee inspected the first car along with a narcotics detection dog, one of the other dogs came loose and attacked the narcotics dog. The employee was separating the dogs when the other dog bit his left ring finger. The last joint of the finger was injured and part of it was bitten off.

An employee was climbing a fixed ladder to perform maintenance in an attic. While unlocking the attic entry, the employee fell from the ladder more than 10 feet to the concrete below. The employee suffered a fractured hip, pelvis, tail bone, arm, and elbow, resulting in hospitalization and surgery.

An employee was drilling a hole into the sealed hold of a vessel so a marine chemist could test its atmosphere. Upon drilling the hole, a gas that was under pressure was released and caught fire at the drill motor, where the employee was holding it. The employee was burned.

An employee was performing restoration activities outside a 45-gallon condensation tank of a boiler system. As they were performing post-maintenance activities after repairing one of the two discharge pumps, one of the discharge valves would not open. The employee closed the intake pump to cool off the system and open the discharge valve. Two employees opened the inlet valve to return the tank to service. After they cracked open the inlet valve, a side wall of the tank blew out, causing the injured employee to suffer steam burns to half their body.

An employee was testing and troubleshooting the gang cylinder valve located in the gang area of the sawmill. The employee's fingertip was amputated by the gang cylinder valve.

An employee was unlocking containers on deck. The employee was de-lashing while standing on the edge of the lid. The lashing bar he was holding came off the cone, causing him to turn 90 degrees and strike a railing behind him. The employee sustained four fractured ribs.

An employee parked a side-by-side on the fixed internal ramp aboard a cargo ship. They exited the side-by-side and went to inspect the cargo below. The side-by-side rolled toward the employee and struck them as they were walking toward the edge of the ramp. The employee was knocked off the ramp and landed on the lower deck approximately 8 feet below. The employee was hospitalized with a fractured shoulder.