Struck by running powered equipment n.e.c. · Cuts, lacerations, punctures without injury to internal structures
At a glance
Federal OSHA recorded a severe workplace injury
at BROX INDUSTRIES, INC., Maurice J Tobin Bridge, CHELSEA, MASSACHUSETTS 02150
on — Cuts, lacerations, punctures without injury to internal structures, affecting the Wrist(s).
Final narrative
On May 15, 2025, an employee was cutting down steel mesh and debris that was protruding from a milled roadway. As the employee began to cut a piece of steel with an angle grinder, he steadied himself with his left hand and the tool contacted the top of his left wrist, resulting in a laceration that required hospitalization.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
More severe injuries in this industry (NAICS 324121)
An employee was stopping traffic at a job site so a piece of equipment could be moved to another location when he was struck by a car. It sent him in the air and he landed on his back, resulting in hospitalization with five fractured ribs, a fractured forearm, and a liver injury.
A truck of asphalt binder was being unloaded. An employee was checking the transfer hose connection on the truck. The gasket on the hose blew out, causing the asphalt binder to shoot out and burn the employee's face, neck, and arms.
A truck driver was on a platform, pulling a tarp on an asphalt load in a six-wheel dump truck. He fell from the platform to the ground and suffered broken ribs.
An employee was using a cutting torch to heat up bolts that had seized up. The bolts caught on fire in a flash burn, and the employee suffered burns to the arms and elbows.
An employee was installing chutes on a cement mixer when their gloved left hand was caught in the pinch point causing the chute to land and crush his fingers. The employee was hospitalized for partially severed index and middle fingers and broken bones.
An employee fell while exiting a trailer. The employee landed on their left side on the pavement, suffering multiple broken ribs on the left side. The employee was hospitalized.
Two employees were setting up a mandrel in the spindle of a machine. The mandrel was side-shifted while an employee's hand was on the mast of a powered industrial truck. The employee suffered crushing injuries that resulted in amputations to the middle and ring fingertips.
An employee had been loading a double deck press. The employee saw a mold had been sent in with the C-hook still attached on the belly bar. As he went to remove the hook from the mold, his right thumb got caught on the C-hook. The employee's thumb was partially amputated.
An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.
An employee was delivering home heating fuel when bees came from the ground and stung the employee's face, neck, torso, and hands. The employee proceeded to shut off the oil flow before losing consciousness. They were hospitalized due to an anaphylactic reaction.