Exposure to electric arc · Electrical burns any degree
At a glance
Federal OSHA recorded a severe workplace injury
at United Parcel Service, 5020 IVY ST., COMMERCE CITY, COLORADO 80022
on — Electrical burns any degree , affecting the Arm(s) unspecified.
Final narrative
An employee had been pulling out a fuse. A motor control center (MCC) bucket exploded and produced an arc flash. The employee sustained burns to both arms.
An employee had been delivering packages when they felt ill and dropped to one knee. The employee was hospitalized for dehydration and heat-related illness.
An employee was terminating cables in a junction box. A loose ground wire came into contact with the bushing, causing a flash that burned the right side of the employee's face and his right hand.
An employee was using a bucket truck hoist to raise secondary aerial wiring. The wire made contact with the primary wire, causing an arc flash. The employee suffered burns to both hands and was hospitalized.
A temporary employee was testing an electrical starter motor. He was placing tape on the starter while the breaker was not engaged, but the starter sent an arc flash that burned his hands and stomach.
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
An employee was moving a large package from a slide when her left arm got caught between the slide (tilt tray) and the package. She was hospitalized with a fractured left arm.
An employee was operating a switch truck at a rail yard. He got out of the switch truck to unlock a container that was attached to a unit in front of him. The switch truck rolled and pinned the employee against the container. The employee sustained a fractured pelvis, a ruptured spleen, and a possible spinal cord injury.
An employee was sidestepping along the catwalk of a railcar when he lost his balance and fell approximately 4 feet to the ground. The employee's right hip was fractured.
An employee was working to realign the two top sections of a set of collapsible rollers (trailer-on-flatcar rollers). The rollers suddenly fell into place and pinched her left index fingertip against the lower sections. She suffered a partial amputation to the fingertip.
An employee was delivering materials. He was doing his pre-delivery inspection on the roof of the jobsite (a warehouse) when he fell through a plexiglass skylight. He landed on his feet on the concrete floor 14 feet below. The employee sustained fractures to his spine, left ulnar/radius, and right heel. The employee required surgery.
An employee was removing packaging from a roll of printing substrate. The blade of their utility knife got stuck. The employee used both hands to free the knife and the blade partially amputated their left little fingertip.
A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.
An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.