ATLAS COMMERCIAL CARPENTRY, LLC

An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.

An employee was standing on the surface of a steel beam about two feet wide. He slipped and fell backward, landing on the concrete ground about 20 feet below. The employee sustained a broken pelvis.

An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.

An employee was working on a platform, raised 6 to 8 feet in the air, to get something off a rack. The employee fell from the platform to the ground and sustained a head injury and injury to multiple body parts.

An employee was preparing to unjam an auger shaft while standing on a forklift-elevated, job-made platform. The employee's wrench slipped off the equipment, causing them to lose their balance and fall. The employee landed on the ground 14 feet below and suffered fractures to the orbital bone, left elbow, and lower back.

An employee was standing on trusses while installing shaftwall and metal channel. He slipped from the bottom chords of the 2x6 trusses and fell approximately 1 foot. A metal C-channel caused a severe laceration to his wrist and ulnar artery.

An employee was operating a circular saw when it jumped and contacted three fingers on their left hand, resulting in lacerations and amputations.

An employee was working on a scaffold installing windows when they fell 6 feet to the ground and impacted their head. The employee sustained head trauma.

An employee was standing on a scaffold approximately 7 feet high and passing plywood sheets to another employee on a single-story roof. The employee fell backward off the scaffold to the ground below and the sheet of plywood fell on him, resulting in fractures to the left side of his jaw and three ribs.

An employee was standing on a 6-foot ladder and nailing shear panels when he lost his balance and fell. The employee's knee became stuck in the ladder and he was hospitalized with a fractured tibia that required surgery.

An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.

A casting machine jammed. An employee's hand was caught in the machine, where a belt line caught and amputated the tip of his finger.

During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.

An employee slipped on condensation on a walkway in a parking garage. She fell and suffered a closed fracture to the neck of the left femur.

An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.