Other fall to lower level 6 to 30 feet · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at CTC Frame & Finish Carpentry, Inc., 3150 Fort Charles Drive, NAPLES, FLORIDA 34102
on — Fractures , affecting the Head and trunk.
Final narrative
An employee was standing on a scaffold approximately 7 feet high and passing plywood sheets to another employee on a single-story roof. The employee fell backward off the scaffold to the ground below and the sheet of plywood fell on him, resulting in fractures to the left side of his jaw and three ribs.
Hospitalized Head and trunk Scaffolds, staging unspecified
More severe injuries at CTC Frame & Finish Carpentry, Inc.
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee was standing on the surface of a steel beam about two feet wide. He slipped and fell backward, landing on the concrete ground about 20 feet below. The employee sustained a broken pelvis.
An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.
An employee was working on a platform, raised 6 to 8 feet in the air, to get something off a rack. The employee fell from the platform to the ground and sustained a head injury and injury to multiple body parts.
An employee was preparing to unjam an auger shaft while standing on a forklift-elevated, job-made platform. The employee's wrench slipped off the equipment, causing them to lose their balance and fall. The employee landed on the ground 14 feet below and suffered fractures to the orbital bone, left elbow, and lower back.
More severe injuries in this industry (NAICS 238350)
An employee was standing on trusses while installing shaftwall and metal channel. He slipped from the bottom chords of the 2x6 trusses and fell approximately 1 foot. A metal C-channel caused a severe laceration to his wrist and ulnar artery.
An employee was working on a scaffold installing windows when they fell 6 feet to the ground and impacted their head. The employee sustained head trauma.
On July 25, 2025, an employee was walking on roof trusses when they fell 10 feet to the ground. The employee was hospitalized with a concussion and a back injury.
An employee was standing on a 6-foot ladder and nailing shear panels when he lost his balance and fell. The employee's knee became stuck in the ladder and he was hospitalized with a fractured tibia that required surgery.
An employee was helping a coworker transport a tall palm tree with a mini skid steer. The employee was severely shocked by a high-voltage electrical wire above the ground.
An employee was retrieving a Christmas tree from a shelf using a ladder. He missed a step and fell to the concrete floor. He sustained injury to his head and wrist.
An employee was operating an agricultural tractor during sugarcane harvesting. The employee sustained a lumbar sprain due to vibration or motion from the tractor.
An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.