Struck by running powered equipment during maintenance, cleaning, testing · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at HMS Inc., 400 Veterans Ave, BILOXI, MISSISSIPPI 39531
on — Fractures , affecting the Upper arm(s).
Final narrative
An employee was performing preventive maintenance on a dryer at a commercial laundry facility. The emergency stop was released, and the dryer broke his left humerus and lacerated his left forearm.
A temporary employee turned off a planer machine, opened the housing, and began clearing a jam. The machine's spinning blade caught his right hand and degloved the index finger.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
More severe injuries in this industry (NAICS 811412)
An employee was using a grinder to cut benches for a condenser change-out. The grinder kicked back and lacerated the employee's left hand above the knuckle, cutting tendons. The grinder's cutting wheel was unguarded at the time.
An employee was moving dies on a hydraulic pan brake closer together so he could bend pieces of sheet metal. The employee's left index, middle, and ring fingers were crushed in the machine, and all three fingers were amputated.
An employee was on a scissor lift, moving a jug of refrigerant onto a roof. The container fell onto his left middle finger, crushing it against the handrail of the scissor lift and and fracturing it.
An employee was replacing the gauge glass of a boiler while standing on the first rung of a 4-foot ladder. He was loosening a corroded valve when the valve snapped off. Steam and hot water discharged onto the employee's upper body. He was hospitalized with second-degree burns to his face, neck, chest, arms, and hands.
An employee was on a 8-foot ladder to replace an actuator on a water valve at a hospital. The employee fell from the ladder onto the tile floor and was hospitalized for a fractured arm, hip and pelvis.
An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.
The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.
An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.
An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.
An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.