Federal OSHA recorded a severe workplace injury
at Mechanical Systems and Service, 100 Medical Park Dr. Bernice La, BERNICE, LOUISIANA 71222
on — Fractures , affecting the Other finger(s) n.e.c..
Final narrative
An employee was on a scissor lift, moving a jug of refrigerant onto a roof. The container fell onto his left middle finger, crushing it against the handrail of the scissor lift and and fracturing it.
Hospitalized Other finger(s) n.e.c. Bottles, jugs, flasks
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
An employee and co-worker were working to unjam and move a 100-pound piece of crossed-up cant timber. The employee lost their grip and the timber fell on their right hand, resulting in crush injuries to the fingers.
An employee was working on a cushion ring (steel). As they lifted the cushion ring with both hands to flip it up, the ring slid down and the employee's right middle fingertip was crushed between the ring and the work table. The employee was hospitalized with a fracture, and their right middle fingertip was amputated.
Two employees were lifting a roll of steel poly bar (50 inches and approximately 150 pounds) from ground level to a height of 4 feet at the 66-inch rubber calendar. One employee dropped the roll, resulting in the poly bar contacting the injured employee's right knee. The employee was hospitalized with fractured right patella.
The injured employee was walking in front of the property by the front door as another employee was removing debris from the roof. The injured employee was struck by a 2 x 4 that was being cleared from the roof. He was knocked unconscious and sustained brain bleeding, as well as head and facial injuries, and required stitches.
More severe injuries in this industry (NAICS 811412)
An employee was using a grinder to cut benches for a condenser change-out. The grinder kicked back and lacerated the employee's left hand above the knuckle, cutting tendons. The grinder's cutting wheel was unguarded at the time.
An employee was moving dies on a hydraulic pan brake closer together so he could bend pieces of sheet metal. The employee's left index, middle, and ring fingers were crushed in the machine, and all three fingers were amputated.
An employee was performing preventive maintenance on a dryer at a commercial laundry facility. The emergency stop was released, and the dryer broke his left humerus and lacerated his left forearm.
An employee was replacing the gauge glass of a boiler while standing on the first rung of a 4-foot ladder. He was loosening a corroded valve when the valve snapped off. Steam and hot water discharged onto the employee's upper body. He was hospitalized with second-degree burns to his face, neck, chest, arms, and hands.
An employee was on a 8-foot ladder to replace an actuator on a water valve at a hospital. The employee fell from the ladder onto the tile floor and was hospitalized for a fractured arm, hip and pelvis.
A driver was exiting his vehicle outside the plant gate when his foot slipped on the top step of the truck. He fell to the ground, landed on his left hip and elbow. The employee was hospitalized with a fractured hip/femur.
A security employee was responding to an urgent call from staff regarding a violent patient. The employee tripped and fell on the floor outside of the stairwell. The employee sustained a closed head injury, contusion of the cerebrum without loss of consciousness, and a closed fracture of the distal end of the right radius.
A temporary employee was testing an electrical starter motor. He was placing tape on the starter while the breaker was not engaged, but the starter sent an arc flash that burned his hands and stomach.
An employee was walking on a sidewalk and stubbed his toe on an elevated portion of concrete, causing him to trip and fall. The employee's right knee was dislocated.