Struck by running powered equipment during maintenance, cleaning, testing · Amputations, avulsions, enucleations unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Speedtech International, Inc., 2410 Norwood Ct, RACINE, WISCONSIN 53403
on — Amputations, avulsions, enucleations unspecified, affecting the Finger or thumb tip(s), nail(s).
Final narrative
An employee was operating an industrial tape cutter machine. He stopped the machine to clear a blockage. While he was clearing the blockage, the machine came down and amputated his left index fingertip. The machine was guarded at the time of the incident.
Amputation Finger or thumb tip(s), nail(s) Special process machinery unspecified
A temporary employee turned off a planer machine, opened the housing, and began clearing a jam. The machine's spinning blade caught his right hand and degloved the index finger.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
More severe injuries in this industry (NAICS 339993)
An employee was setting up the dies on a metal forming machine. He was feeding some material through and jogging the machine when his left middle finder got caught in the point of operation and the fingertip was amputated. The machine was not guarded at the time.
An employee was replacing the trim die on a machine when the machine's stored energy caused the die to come down and contact their fingers. The employee sustained a laceration and fractured left ring and middle fingers.
An employee was pouring nitric acid into a plating bath tub. A mechanical trolley that traveled over the tank approached and startled him. This caused him to spill the acid onto his right arm. His arm was burned from the wrist to the elbow.
An employee had attached a new hammer to a machine that shaped and formed coils of steel. When the employee hit "run" to operate the machine, the hammer struck the employee on the right arm. The employee suffered a broken humerus that required surgery.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.
An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.