Global 3, LTD

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.

An employee was attempting to lift a steel beam from a horizontal, stacked position to a vertical position using a crane. They had placed two hooks on the east side of the beam on the flange. As the employee was hoisting the crane, the beam began to shift and pulled the employee forward onto the stack. When the material shifted, the hooks released and the material fell, pinning the employee between the two beams. The employee was hospitalized with soft tissue contusions on their proximal right thigh and interior left thigh.

An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.

An employee was rigging I-beams. An I-beam slid off the stack of I-beams and fractured the employee's leg.

An employee turned a corner while walking, tripped over the corner of a pallet on the floor, fell onto her arm, and broke it. She was hospitalized, requiring surgery.

An employee was moving a transformer from inside a shop. He was rolling it down a ramp when it tipped over onto his right foot and big toe, resulting in crush injuries and a laceration.

An employee was using an industrial magnet to lift and maneuver a weldment. While the frame was being set down on the welding table, the magnet disengaged prematurely; the frame fell and crushed the employee's left ring and middle fingers. The employee underwent medical amputations to the middle finger (at the first knuckle) and the ring finger (just past the second knuckle).

An employee was working on an order when they were struck by a forklift. This caused the employee to bump into a machine. The employee suffered a laceration to the right thigh, requiring hospitalization.

An employee was clearing the chute of a tube cutter machine due to tubing that was stuck. Their right middle fingertip was amputated by the cutting blade.

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.

An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.