Other fall to lower level less than 6 feet · Traumatic injuries or exposures unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Masa Milling, Inc., 1703 Wolf Industrial Dr, GREENVILLE, ILLINOIS 62246
on — Traumatic injuries or exposures unspecified, affecting the Ankle(s) and leg(s) n.e.c..
Final narrative
An employee was climbing an A-frame ladder to adjust an exhaust pipe on the wall to let the heat out. The employee fell 4-5 feet and injured his right tibia and ankle.
Hospitalized Ankle(s) and leg(s) n.e.c. Step ladders
An employee was investigating a plug in a system when their left middle fingertip was caught in the airlock, resulting in amputation at the first knuckle.
An employee fell while exiting a trailer. The employee landed on their left side on the pavement, suffering multiple broken ribs on the left side. The employee was hospitalized.
A driver was exiting his vehicle outside the plant gate when his foot slipped on the top step of the truck. He fell to the ground, landed on his left hip and elbow. The employee was hospitalized with a fractured hip/femur.
Two employees were removing a service lift platform from the back of a radar system. While handling the service lift platform, employee 2 was standing on the back of the radar and lost their footing, causing the service lift platform to shift and fall. The injured employee then fell from the top of the platform electronic subsystem (PES) to the floor, approximately 56 inches. The injured employee fractured his left elbow and left hip.
An employee fell from a loading dock to the ground 2-3 feet below. She suffered a compound fracture of the left hip and was hospitalized, requiring surgery.
An employee assisted in cleaning material from a conveyor pit. After the pit was cleaned, the employee proceeded to replace metal safety plates to ensure other employees did not fall into the pit. While replacing one of the last plates, the employee mis-stepped and fell approximately 5 feet into the pit. The employee was hospitalized with back/side bruising, elbow bruising, bone bruises, and/or fractured ribs.
More severe injuries in this industry (NAICS 311211)
An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.
An employee was checking a flour roll stand for a blockage. The employee's right hand was caught in an ingoing nip point on the machine, causing partial amputations to the thumb and middle, ring, and little fingers.
An employee was adjusting the position of a dumpster that was attached to a forklift with a chain when their left little finger was crushed, resulting in a fingertip amputation and surgery.
An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.
An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.