Federal OSHA recorded a severe workplace injury
at Manhattan Road & Bridge Company LLC, Northwest Corner of I-44 / Highway 75, near W. 51st St., TULSA, OKLAHOMA 74107
on — Fractures , affecting the Trunk and other upper extremities.
Watch Manhattan Road & Bridge Company LLC — freeGet an email when a new federal OSHA severe-injury report for Manhattan Road & Bridge Company LLC is published. One employer, no account, unsubscribe in one click.
Final narrative
An employee was operating a forklift on a slope to move a concrete barrier wall. The barrier wall swung due to the rough terrain, causing the forklift to overturn. The employee suffered fractured vertebrae in their back, a fractured shoulder, and a head laceration.
Hospitalized Trunk and other upper extremities Forklift, order picker, platform truck powered
An employee was mowing a residential lawn at a client's house. The mower slid on the land and tipped over onto him. The employee was hospitalized with a fractured vertebra in the neck and partial paralysis.
An employee was driving a forklift when its right front wheel dropped off a 6-inch curb. The forklift rolled over and trapped him against the concrete surface. He suffered a broken pelvis, ribs, and collarbone, as well as a collapsed lung.
An employee was operating a utility task vehicle (UTV). During a left turn, the vehicle rolled over on its right side. The employee suffered a lumbar strain and fractures to four lower-back vertebrae. She was hospitalized.
An employee was loading a telehandler onto a trailer and the right wheels were misaligned with the trailer, causing the telehandler to tip and fall to the right. The employee went to exit the telehandler as it fell, striking his head on the cage and frame of the telehandler. The employee sustained a concussion, a head laceration, and fractured vertebrae.
An employee was driving an ATV when it overturned and rolled onto its side. The employee sustained a fractured elbow requiring hospitalization and surgery.
More severe injuries in this industry (NAICS 237310)
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.
A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.
An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.
An employee was working with paving equipment and heard a noise on the opposite side of the machine he was working on. When the machine stopped, the employee went to the opposite side and crouched down to investigate the noise. A mini track loader backed up and drove over the employee's leg. The employee sustained fractures to their lower leg, ankle, and foot.
An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.
An employee was working in the food service warehouse when he experienced chest pain, difficulty breathing, and lost consciousness. The employee sustained carbon monoxide poisoning.
An employee was cutting a piece of metal rod with a metal cutting machine. His right middle finger became caught between the rod and the machine's table. The employee's fingertip was partially amputated.
An employee was working at her desk. She went to stand up and fell to the floor beside the desk. The employee sustained a hip displacement and required surgery.
An employee was processing wood boards at a chop saw when the saw malfunctioned and the blade cut her left hand and fingers. She was hospitalized and her little finger was surgically amputated.
SafetyIncidentsAsk about the data, reports & pricing