Struck by dislodged or detached object(s) · Cuts, lacerations, punctures without injury to internal structures
At a glance
Federal OSHA recorded a severe workplace injury
at POWER MOTIVE CORPORATION, 5000 VASQUEZ BLVD, DENVER, COLORADO 80216
on — Cuts, lacerations, punctures without injury to internal structures, affecting the Buttock(s).
Final narrative
An employee was working on an excavator's tracks. He was swinging a sledgehammer to finish pushing a metal tractor pin into the track links. A hammer-blow caused a piece of the pin to fly off, ricochet, and embed itself in his buttock. He was hospitalized, requiring surgery.
An employee was removing a plow blade from a plow frame when the blade fell forward and struck the employee's left shin. The blade slid down the employee's left leg as the employee fell backward. The employee sustained a fractured left femur.
An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.
A service crew was pulling a pump and motor from a well. After breaking a joint of pipe loose from another joint, an employee grabbed the chain tongs to prevent the pipe from spinning in the well, so the crew could continue taking it apart. The bolt that attaches the chain to the handle of the chain tongs broke, causing the chain to swing around and strike the employee's lower right leg. The chain severely punctured his leg and fractured his tibia.
An employee was using a handheld grinder to cut a bolt. The grinding wheel broke apart and a fragment struck the employee s right hand, causing a laceration to the palm near the little finger.
An employee was operating a brake press when the top die broke, causing the bottom die to roll out and onto the employee's legs. Both of the employee's legs were crushed below the knee, and both legs were partially amputated. The employee's left leg was also fractured above the knee.
A pressurized aircraft nose landing gear strut assembly was being disassembled. The gland nut dislodged under pressure and made contact with an employee's left hand, breaking it.
More severe injuries in this industry (NAICS 532412)
An excavator bucket was being removed. An employee was pulling a snap ring to remove a pin and lost his grip. The high-tension snap ring recoiled and his left middle fingertip was amputated by the snap ring.
An employee was walking between service bays. He came into contact with a trailer hitch, which was sticking out of the back of a lawn mower, and fell to the concrete floor. He landed on his right side and suffered a broken hip.
An employee was taking a scissor lift off a flatbed trailer. While using the remote operator controls and walking alongside the lift, the wheel of the lift turned in the wrong direction, causing it to strike the employee and roll over his left ankle. The employee was hospitalized with two broken bones in his ankle.
An employee was picking up crane pads to put onto their trailer. Their finger got pinched between pads, resulting in an amputation involving the loss of skin.
At about 8:30 a.m. on August 14, 2025, an EquipmentShare employee was loading a telehandler onto a delivery truck. While the telehandler was being backed onto the truck, it went off the side. The employee suffered several broken ribs and a broken wrist.
An employee was delivering materials. He was doing his pre-delivery inspection on the roof of the jobsite (a warehouse) when he fell through a plexiglass skylight. He landed on his feet on the concrete floor 14 feet below. The employee sustained fractures to his spine, left ulnar/radius, and right heel. The employee required surgery.
An employee was removing packaging from a roll of printing substrate. The blade of their utility knife got stuck. The employee used both hands to free the knife and the blade partially amputated their left little fingertip.
A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.
An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.