Other fall to lower level 6 to 30 feet · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at American Cast Iron Pipe Company, 1501 31st Ave N, BIRMINGHAM, ALABAMA 35207
on — Fractures , affecting the Rib(s), oblique area.
Final narrative
An employee was performing maintenance/electrical work inside a substation, and used a ladder to access the top of a panel box. The employee fell 8-9 feet from the top of the panel box to the ground. The employee was hospitalized with fractures to their ribs and a shoulder injury.
Hospitalized Rib(s), oblique area Switchboards, panels, fuses
More severe injuries at American Cast Iron Pipe Company
An employee was attending a pipe jack station where the edges of pipes are straightened with a mold and die. The employee was lowering and moving in a pipe when the die of the pipe jack hit the pipe, fell off, and hit the employee's left hand. The employee's left ring finger was crushed between the pipe and die, resulting in an amputation to the first knuckle.
An employee was preparing a stiff-leg pipe for installation on an overhead crane. The pipe fell and struck the employee's lower right leg, lacerating it. The employee was hospitalized.
An employee was trying to roll a crossed iron pipe back into the fixed metal pipe saddle. He lost his balance and as he tried to catch himself, his index finger was caught between the pipe and the pipe saddle crushing it. The fingertip was surgically amputated at the first knuckle. His middle and ring fingers sustained contusions.
An employee's hand struck a grinding wheel, suffering a fractured fingertip, a deep laceration to the index finger, and an abrasion on the middle finger. The employee was hospitalized.
An employee stepped through a hatch on a catwalk and fell approximately seven feet to a platform below injuring his shoulder. The employee then rolled off the platform approximately another seven feet resulting in multiple broken bones. The employee was hospitalized.
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee was standing on the surface of a steel beam about two feet wide. He slipped and fell backward, landing on the concrete ground about 20 feet below. The employee sustained a broken pelvis.
An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.
An employee was working on a platform, raised 6 to 8 feet in the air, to get something off a rack. The employee fell from the platform to the ground and sustained a head injury and injury to multiple body parts.
An employee was preparing to unjam an auger shaft while standing on a forklift-elevated, job-made platform. The employee's wrench slipped off the equipment, causing them to lose their balance and fall. The employee landed on the ground 14 feet below and suffered fractures to the orbital bone, left elbow, and lower back.
More severe injuries in this industry (NAICS 331511)
An employee was realigning two halves of a core box on a core-making machine. Pneumatic pressure released, causing the core box to close on the employee's right thumb. The thumb tip was amputated between the nail and the knuckle.
An employee's hand was caught in a pinch point in the area of a conveyor for a flask running out of a foundry molding machine. The employee's ring finger was crushed and partially amputated at the base.
An employee noticed a block was out of place under the weighted mold frame. The employee used another block to push the block out and replace it. When the block came out, the frame came down on his right ring and little fingers. The employee sustained a fracture and partial amputation to the ring fingertip.
An employee was using a fork truck to move a tub containing molten iron that had been drained from the cupula. The tub tipped over and the molten metal came in contact with water. This caused the molten iron to splash back and burn the employee's upper torso.
An employee was attempting to transfer an iron pipe from the threader machine using a crane. When the employee grabbed ahold of straps used to move the iron pipe and pushed down on the strap, their left hand was caught between the strap and the iron pipe. The employee sustained an injury to the fingers of the hand that required surgery and hospitalization.
An employee was traveling down the maintenance aisle of a warehouse on a single-pallet front rider jack. The jack malfunctioned, causing the brakes to apply; the employee fell forward onto the concrete warehouse floor. The employee suffered an injury to the left leg and was hospitalized, requiring surgery.
An employee was operating a metal roller machine to roll a small piece of metal. The employee's right index finger became caught between the metal and the machine, and the fingertip was amputated.
An employee was directing a truck driver to a dump site when the truck's peanut trailer slipped off the kingpin. As the trailer fell, a ladder attached to it lacerated the employee's ear. The employee was hospitalized.
An employee was unloading a forklift from a trailer to the ground. The employee was climbing down the ladder of the trailer when their foot slipped through one of the rungs, causing them to fall backward onto the forklift forks. The employee was hospitalized for fractured ribs.