RICHLAND CENTER, WISCONSIN—
Erie Construction Mid-West, LLC
Injured by object held or wielded by person · Amputations involving bone loss
At a glance
Federal OSHA recorded a severe workplace injury at Erie Construction Mid-West, LLC, 28954 Wisconsin 80, RICHLAND CENTER, WISCONSIN 53581 on — Amputations involving bone loss, affecting the Finger or thumb tip(s), nail(s).
Final narrative
An employee was training a subcontractor on how to operate a steel roofing cutter to cut metal shingles on a residential roofing job. The handle of the tool pinched the employee's right little finger, resulting in amputation of the fingertip.
More severe injuries at Erie Construction Mid-West, LLC
RED BUD, ILLINOIS—
Erie Construction Mid-West, LLC
An employee was inspecting the attic in a home. The employee stepped off the drop-down attic ladder onto drywall, fell through, and landed on the floor about 10 feet below. He suffered a broken left tibia.
DORCHESTER, ILLINOIS—
Erie Construction Mid-West, LLC
An employee fell through an attic to the concrete floor below, resulting in broken teeth and a fractured ankle.
View Erie Construction Mid-West, LLC's full OSHA safety record →
Similar incidents · Same event type
LONGMONT, COLORADO—
Circle Graphics, Inc.
An employee was removing packaging from a roll of printing substrate. The blade of their utility knife got stuck. The employee used both hands to free the knife and the blade partially amputated their left little fingertip.
VALHALLA, NEW YORK—
Spellman High Voltage Electronics Corporation - Valhalla
An employee was disassembling a pressurized unit using a driver drill. When the unit was disassembled, it caused a kickback from the tube head, causing the drill to strike the employee's left forearm. They sustained a diaphyseal fracture to their left radius and ulna, which required surgery.
JACKSONVILLE, FLORIDA—
CONTAINER GRAPHICS CORP
An employee was using a box cutter when it cut the tip of his left thumb resulting in a fingertip amputation.
HOUSTON, TEXAS—
Village Plumbing, Air & Electric
While working at a customer's residence, an employee was cutting tape with a box cutter to wrap insulation for a piece of pipe. The box cutter struck a hardened object within the wall causing it to bounce back and puncture the employee's right eye. The employee was hospitalized.
AUSTIN, TEXAS—
Rock Labor LLC
An employee was using the pipe-and-wrench method to loosen a seized bolt on a roof truss. A technician from another company was on the other side of the truss doing the same action with the same method. The employee's socket slipped off the bolt and his left hand was crushed against the truss, resulting in injuries to the index and little fingers, requiring hospitalization, surgery, and amputation of the index finger.
More severe injuries in this industry (NAICS 236115)
MIDLAND, TEXAS—
Betenbough Homes, LLC
An employee was unloading frameless mirrors from a trailer. When unstrapped, the mirrors fell over onto the employee, who suffered a skull fracture, a brain bleed and blood clot, a broken left ankle, and lacerations.
SEATTLE, WASHINGTON—
Industrial Resources, Inc.
An employee was drilling a hole into the sealed hold of a vessel so a marine chemist could test its atmosphere. Upon drilling the hole, a gas that was under pressure was released and caught fire at the drill motor, where the employee was holding it. The employee was burned.
RED BUD, ILLINOIS—
Erie Construction Mid-West, LLC
An employee was inspecting the attic in a home. The employee stepped off the drop-down attic ladder onto drywall, fell through, and landed on the floor about 10 feet below. He suffered a broken left tibia.
MILTON, WEST VIRGINIA—
Asplundh Construction LLC
An employee went aloft in a bucket truck to install a rubber cover-up for the pole set. He was proceeding to frame and transfer the conductors to the new pole when he sustained electrical burns on his left side, arm, and leg that required hospitalization.
TULSA, OKLAHOMA—
Forza Construction Services
An employee was positioned on a scaffold. They were using a level to adjust a pole and place bricks on the side of a wall. They fell approximately 30 feet from the scaffold to the ground, resulting in fractures to their back, rib, and heel.
More severe injuries in WISCONSIN
MADISON, WISCONSIN—
RG Professional Carpenter, Inc.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
FRANKLIN, WISCONSIN—
General Thermodynamics, Inc.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
SAINT CLOUD, WISCONSIN—
Sargento Foods Inc
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
HIXTON, WISCONSIN—
Asher Enterprises, Inc.
An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.
VERONA, WISCONSIN—
Consolidated Electrical Distributors Inc.
An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.