Exposure to electric arc · Electrical burns any degree
At a glance
Federal OSHA recorded a severe workplace injury
at Advanced Air Technologies, Inc., 907 Millard Dr, HENDERSON, TEXAS 75652
on — Electrical burns any degree , affecting the Head and extremities.
Final narrative
An employee was using a multimeter to ensure proper power supply to a newly repaired rotary screw air compressor before running a voltage test. An electrical arc flash occurred, resulting in burns to both the employee's hands and their face.
An employee was terminating cables in a junction box. A loose ground wire came into contact with the bushing, causing a flash that burned the right side of the employee's face and his right hand.
An employee was using a bucket truck hoist to raise secondary aerial wiring. The wire made contact with the primary wire, causing an arc flash. The employee suffered burns to both hands and was hospitalized.
A temporary employee was testing an electrical starter motor. He was placing tape on the starter while the breaker was not engaged, but the starter sent an arc flash that burned his hands and stomach.
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
An employee was on the roof of a building, putting plastic around a dust collector, when their left middle finger was caught in a grinder insider the dust collector. The employee suffered a partial amputation to the left middle finger.
On August 4, 2025, an employee was fixing a jammed carousel and using a hook to manually adjust the carousel by hand. The hook slipped off and the employee fell to the concrete ground, resulting in hospitalization for a fractured right hip.
An employee was replacing a screen on a rooftop HVAC unit when the rotating exhaust fan blade contacted their right index finger, resulting in a laceration that required hospitalization and the surgical amputation at the first knuckle.
An employee was changing an air filter when the door to the HVAC closed due to wind. The employee sustained an amputation to the left thumb at the nailbed.
An employee was removing a filter from inside a mold when a switch malfunctioned and the mold clamped on his left hand, crushing it. The employee was hospitalized.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.