Struck by other propelled object or substance n.e.c. · Multiple severe wounds and internal injuries
At a glance
Federal OSHA recorded a severe workplace injury
at Jadwin Lumber Company, 1619 Scenic Rivers Boulevard, SALEM, MISSOURI 65560
on — Multiple severe wounds and internal injuries, affecting the Multiple body parts unspecified.
Final narrative
An employee was feeding boards into an edger. They fed a board in and then adjusted the blade for a second board that was wider. When they fed the second board into the edger, it hit the first board and kicked back, striking the employee in the chest. They sustained injuries including a spine fracture, an injured pancreas, as well as potential injuries to their spleen, liver, and intestine. The employee was hospitalized and required surgery.
Hospitalized Multiple body parts unspecified Dimensional lumber
The injured employee was assisting in the disassembly phase after a radar array had been lowered and secured. The crew began removing load bearing pins from an overhead crane to free the radome. A load bearing pin was stuck. The injured employee went to remove the pin manually as a second team member applied pressure from the opposite side. The pin unexpectedly released and struck the injured employee s right thumb, resulting in partial amputation of the distal phalanx including an open distal phalanx fracture and nail bed laceration.
An employee was shoveling excess material (spillage) that consisted of dry mix, sand, aggregate and cement. As he was shoveling, some material blew back in his face and around his safety glasses. He got a piece of metal in his left eye that required surgery. The employee was hospitalized.
An employee was helping an operator to pull a cable off a winch. The operator pulled in the line when it hooked some tree brush. The brush then whipped around and struck the employee's arm, resulting in a broken arm.
A co-worker was adjusting an overhead bracket with an impact wrench when the tool flew out of their hand and struck the injured employee in the face. The injured employee sustained an injury to their left eye.
An employee was repairing a photo eye on the infeed roll case when they dropped a tool. The employee went to grab the tool and his fingers contacted the chain and sprocket of the infeed roll case. His fingers were pulled into the pinch point and the fingertips were crushed, resulting in amputation of one fingertip.
An employee was troubleshooting dispersing equipment. A belt and pulley system was energized, and the moving belt caught the employee's right ring finger. He suffered a partial amputation at the first knuckle, below the nail.
An employee was cleaning the photo eye sensors of a piece of equipment between the saw that cuts lumber into lengths and boards. The employee stepped on a metal grate that gave way and fell 8-10 feet. The employee was able to remove himself from the conveyor. His tibia was fractured just below the knee.
While refilling a lubricant tank, an employee observed that a pump was not operating correctly. While troubleshooting the issue, the employee reached toward the back of the pump to check for proper airflow. Their left index finger contacted moving components in the pump's piston mechanism, resulting in partial amputation of the fingertip.
An employee was readjusting a safety hook to remove hardware from gang forms when his feet slipped. He fell to the ground, resulting in a broken left arm and wrist.
An employee was on a step ladder in a store aisle, making room on shelving for merchandise. She fell from the step ladder to the floor, suffering two fractures in her left leg. She was hospitalized, requiring surgery.
An employee was closing the side cargo door to a company van. The tip of his finger got caught between the door and the door jamb, resulting in a partial amputation.
An employee lost his footing while climbing an inclined ladder. He stumbled down one step and was able to stabilize himself by holding the railing and twisting his body, but he suffered an internal abdominal injury and was hospitalized.