105,313Records 71,083Employers 85,290Hospitalizations 27,770Amputations 2015-01-01 2025-10-31
Safety Incidents OSHA Severe Injury Reports · 2015–2025

D & S Welding, LLC

Explosion of pressure vessel, piping, or tire · Thermal burns degree unspecified

Federal OSHA recorded a severe workplace injury at D & S Welding, LLC, 48227 249th Street, SHERMAN, SOUTH DAKOTA 57030 on — Thermal burns degree unspecified, affecting the Part of body unspecified.

An employee was cutting the top of an empty scrap barrel that previously contained antifreeze. The bottom of the barrel blew out due to pressure that built up and caused his jeans to catch fire, resulting in burns.

Hospitalized Part of body unspecified Barrels, drums, cans nonpressurized

Downtown Recycling, Inc.

An employee was conducting torching operations using oxygen and propane to cut metal beams within the recycling laydown area. The employee used a hose with an air chuck connection to fill up the yard pickup truck's back tire with oxygen. The tire blew up which caused the oxygen to ignite. The employee sustained fractures, internal injuries, burns, and lacerations.

Tire Discounters, Inc.

An employee was replacing a tire on a wheelbarrow when the tire exploded. The employee sustained fractures to his right hand and an abrasion to the right side of his face. The employee was hospitalized and required surgery on his right hand.

Accel Compression

An employee was checking the pressure gauge on a unit from a step stool. As he was stepping down, the ball valve ruptured and grazed the side of his left hand. The employee was hospitalized with an injury to the hand near the thumb and required surgery.

Van Eaton Ready Mix, Inc.

A mechanic was changing out an air spring on a concrete mixer truck cab. The air spring was receiving higher air pressure than it was designed to use, because of a faulty level check valve. This increased pressure caused the air spring to burst. Its top portion separated and struck the employee's left forearm, causing a laceration and fracture. The employee was hospitalized, requiring surgery.

ROCKY MOUNTAIN INSPECTION SERVICES, INC.

An employee was hydro testing and pressurizing a pipe when it blew. The lid struck the employee, causing a gash to his elbow and injury to his abdominal area that required surgery.

New Millennium Building Systems

An employee was moving metal out of a cart. He had removed one piece and was working to move another when the metal shifted. His right ring finger was crushed between the two pieces, and he suffered a partial amputation to the finger pad at the tip.

Coastal Welding Supply

An employee was at the loading dock working to manually move an oversized load off of a pallet that was sitting on another pallet. The oversized load (a gas cylinder cradle) tipped over and crushed the employee's right leg against the ground. The employee sustained a fracture to their ankle/leg requiring surgery.

WeldFit

An employee was depressurizing a line stop actuator when their left arm was struck by a threaded, 2-inch nipple from the side of the line stop housing. The employee sustained fractures to their left arm and a rib.

The Lincoln Electric Company

An employee was moving extra wire out of a cleaning tank by using the tank's jogging function. Two of the employee's right-hand fingers were caught on the last strand going around the acid roll, and the employee suffered an amputation to the right little fingertip.

PARADISE WELDING, INC.

An employee was acting as a spotter for a forklift. The forklift was traveling in the parking lot with a hoisted bundle of angle iron when a slight slope in the asphalt caused the load to shift and tighten the eye of the choker (rigging). The rigging strap's hoisting eye failed and the load fell to the ground, landing on the employee's left foot and fracturing it.

Simon Contractors of South Dakota, Inc.

An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.

Agtegra Cooperative

An employee was walking past a crossover conveyor when a ramp came down and hit them in the back. The employee sustained a broken back vertebra, as well as a concussion, and was hospitalized.

Martin Brower Distribution Center

An employee was using a hook tool to pull a pallet onto the lift gate of a tractor trailer. The hook detached from the underside of the pallet, causing the employee to fall backward off the lift gate. The employee landed on the concrete parking lot about 5 feet below, suffering fractures to the skull and two thoracic vertebrae.

Mayfield Truss, LLC

An employee was walking on a truss table when he lost his balance and fell approximately 3 feet to the floor. The employee sustained a dislocated and fractured left ankle.