Struck by falling part of vehicle or machine, still attached · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Conner Holdings, LLC, 4153 BYPASS ROAD, HOMERVILLE, GEORGIA 31634
on — Fractures , affecting the Hip(s) and leg(s) n.e.c..
Final narrative
An employee was replacing the wear pan in a wood chipper when a metal sawdust pipe attached to the machine fell from above, pinning him against the machine. The employee suffered a broken right femur, right hip, and left hip.
Hospitalized Hip(s) and leg(s) n.e.c. Pipes, tubes metal
An employee was standing at the rear of a machine and the machine's mesh tray fell down onto the rear of the machine, crushing his left hand against the read lift. The employee sustained fractures and a laceration to their left hand and was hospitalized.
An employee had been tasked with hauling large rocks. There was a rock caught in the tailgate of the dump truck that was preventing it from opening. He went to get the rock out and the tailgate came down, crushing his right middle fingertip. The employee sustained a fracture of the distal phalanx and required surgery.
Two employees were working on a forklift with its mast in the air when a chain came loose and the carriage fell down on them. The injured employee was hospitalized with a fractured left ankle, a laceration on the left side of their forehead, and a fractured L1 vertebra.
An employee was hooking up a hydraulic attachment on a forklift. When pressure was released from the hydraulic system's hose, the arm of the forklift came down on the employee's left foot and broke it.
An employee was working to drop the tailgate on a rented dump truck. His right thumb was caught in a pinch point between the tailgate and a retaining chain. He suffered a partial amputation to the thumb, past the last knuckle.
More severe injuries in this industry (NAICS 321113)
An employee was repairing a photo eye on the infeed roll case when they dropped a tool. The employee went to grab the tool and his fingers contacted the chain and sprocket of the infeed roll case. His fingers were pulled into the pinch point and the fingertips were crushed, resulting in amputation of one fingertip.
An employee was troubleshooting dispersing equipment. A belt and pulley system was energized, and the moving belt caught the employee's right ring finger. He suffered a partial amputation at the first knuckle, below the nail.
An employee was cleaning the photo eye sensors of a piece of equipment between the saw that cuts lumber into lengths and boards. The employee stepped on a metal grate that gave way and fell 8-10 feet. The employee was able to remove himself from the conveyor. His tibia was fractured just below the knee.
While refilling a lubricant tank, an employee observed that a pump was not operating correctly. While troubleshooting the issue, the employee reached toward the back of the pump to check for proper airflow. Their left index finger contacted moving components in the pump's piston mechanism, resulting in partial amputation of the fingertip.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.