Direct exposure to electricity greater than 220 volts · Electrical burns any degree
At a glance
Federal OSHA recorded a severe workplace injury
at Metts Powerline Construction, Inc., Blevins Rd, BENNINGTON, OKLAHOMA 74723
on — Electrical burns any degree , affecting the Foot (feet), toe(s) unspecified.
Final narrative
Two employees exited their vehicle to assess a fully-downed power pole. The injured employee approached the downed pole to examine it more closely when their feet got caught underneath the energized phase and the ground of the pole, resulting in electrical burns to both feet.
Hospitalized Foot (feet), toe(s) unspecified Power lines, transformers, convertors
A crew was changing out a single-phase pole. The injured employee was framing the pole approximately 30 feet from the base. As they were loosening the armor rod clamp, the conductor broke and the wire fell to the ground, landing on the employee's right hand. The employee suffered electrical burns to their right hand and both knees.
An employee (a lineman) was working to restore power by installing a hand line when he contacted a high-voltage device (7,200 volts), resulting in electrical burns to his upper body and hands.
An employee was working from a bucket truck to remove a bolt from an attachment on an energized power line pole. The employee came into contact with the energized phase, resulting in an electrical shock of 7,200 volts. The employee was hospitalized. Protective gloves were not worn at the time of the incident.
On September 29, 2025, an employee was installing a fiber optic line at a residential site. His shoulder contacted the 7,600-kilowatt power line, resulting in an electrical shock. The employee was hospitalized.
An employee went aloft in a bucket truck to install a rubber cover-up for the pole set. He was proceeding to frame and transfer the conductors to the new pole when he sustained electrical burns on his left side, arm, and leg that required hospitalization.
More severe injuries in this industry (NAICS 237130)
An employee was terminating cables in a junction box. A loose ground wire came into contact with the bushing, causing a flash that burned the right side of the employee's face and his right hand.
An employee was using a bucket truck hoist to raise secondary aerial wiring. The wire made contact with the primary wire, causing an arc flash. The employee suffered burns to both hands and was hospitalized.
An employee was terminating conductors to buss bars inside the secondary compartment of a single-phase transformer. An arc flash occurred, causing burns to the soft tissue of the employee's face.
An employee was securing the claw of a grapple truck to the truck bed. His left little finger was caught between the tie down strap and the rub rail of the truck, resulting in partial amputation of the finger.
An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.
An employee was working in the food service warehouse when he experienced chest pain, difficulty breathing, and lost consciousness. The employee sustained carbon monoxide poisoning.
An employee was cutting a piece of metal rod with a metal cutting machine. His right middle finger became caught between the rod and the machine's table. The employee's fingertip was partially amputated.
An employee was working at her desk. She went to stand up and fell to the floor beside the desk. The employee sustained a hip displacement and required surgery.
An employee was processing wood boards at a chop saw when the saw malfunctioned and the blade cut her left hand and fingers. She was hospitalized and her little finger was surgically amputated.