Exposure to electric arc · Electrical burns any degree
At a glance
Federal OSHA recorded a severe workplace injury
at Standard Utility Construction, Inc., 1340 Wooded Lake Dr., MESQUITE, TEXAS 75150
on — Electrical burns any degree , affecting the Ears and facial region unspecified.
Final narrative
An employee was terminating conductors to buss bars inside the secondary compartment of a single-phase transformer. An arc flash occurred, causing burns to the soft tissue of the employee's face.
Hospitalized Ears and facial region unspecified Power lines, transformers, convertors
More severe injuries at Standard Utility Construction, Inc.
Within 15 minutes of being on the job, an employee became ill. He continued to work throughout the day, taking frequent rest breaks. The employee was having cramps on his left side throughout the day. After finishing the day, the employee went home and was later hospitalized with dehydration, suspected heat exhaustion, and acute kidney failure.
An employee was installing new wire during construction of a residential townhome and contacted a live pedestal buss bar resulting in electrocution. The employee was wearing flame resistant clothing and electrical protector gloves at the time.
An employee was standing at the rear of a digger derrick truck loading it. The employee's finger was caught between a railing and a concrete pier as it was being loaded into the truck. The left index fingertip was amputated.
An employee was terminating cables in a junction box. A loose ground wire came into contact with the bushing, causing a flash that burned the right side of the employee's face and his right hand.
An employee was using a bucket truck hoist to raise secondary aerial wiring. The wire made contact with the primary wire, causing an arc flash. The employee suffered burns to both hands and was hospitalized.
A temporary employee was testing an electrical starter motor. He was placing tape on the starter while the breaker was not engaged, but the starter sent an arc flash that burned his hands and stomach.
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
An employee was terminating cables in a junction box. A loose ground wire came into contact with the bushing, causing a flash that burned the right side of the employee's face and his right hand.
An employee was using a bucket truck hoist to raise secondary aerial wiring. The wire made contact with the primary wire, causing an arc flash. The employee suffered burns to both hands and was hospitalized.
An employee was securing the claw of a grapple truck to the truck bed. His left little finger was caught between the tie down strap and the rub rail of the truck, resulting in partial amputation of the finger.
An employee was working to build an electrical substation. He was cleaning out the inside of a fixed section of a PVC pipe on the end that was furthest from an excavator. The excavator was outside of the trench and more than 25 feet away when it moved a pipe, pinching the employee's right arm between the two pipes. The employee's forearm was fractured.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.