K&H Precision Products, Inc.

An employee was helping a coworker transport a tall palm tree with a mini skid steer. The employee was severely shocked by a high-voltage electrical wire above the ground.

An employee was looking at a transformer in a building. He connected probes to the bushing and ground wire and was shocked. The employee suffered second-degree burns to his left hand.

On September 15, 2025, at approximately 5:00 PM, a five-person crew of line workers was installing new insulators on a transmission line that was de-energized and grounded. The injured employee was shocked by induced voltage and sustained burns to the palms of both hands.

On 8/27/2025, an electrician was working on a live lighting circuit and sustained an electric electric shock. He was seizing and required CPR. The employee was hospitalized.

An employee was installing a PLC onto a washer. After he hooked it up, it did not power up when turned on. While the employee was checking the leads with a voltage meter, he was shocked through the left little finger, chest, and right arm from a transformer above him. He was hospitalized.

An employee was trimming manufactured parts using a two-hand control, C-frame trim press. They were manipulating parts in the machine when their hand contacted the controls that energized the machine. The employee sustained amputations to their left index finger and left thumb.

Two employees were operating an aluminum die casting machine when a piston that pushed molten aluminum into the mold stopped dispensing aluminum correctly. After they had spent several hours fixing the issue, the machine cycled and the die closed on one employee's right hand. The employee suffered amputations to the index fingertip and the thumb at the knuckle.

An employee was operating a mold machine when a pouring ladle that was coated with a water-based paste was submerged in molten aluminum. The moisture caused an explosion, resulting in severe burns over his body.

On September 10, 2024, at approximately 5:55 AM, an employee suffered burns to his right hand as he was removing a ladle from a furnace and the cup made contact with the side of the furnace, splashing molten aluminum into his glove. The employee was hospitalized with burns to his right hand.

An employee was training a new employee to operate the trim press. As she removed a part from the press dies, the die activated and her right hand was caught between the die and the die plates, resulting in crush injuries to four fingers and amputations.

An employee was cleaning leaves with a backpack blower when he fell from a ladder, resulting in injuries to his head, neck, and back.

An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.

An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.

An employee's right middle finger was caught in a nip point. The employee suffered an amputation to the middle finger at the first knuckle.

An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.