Associated Metal Forming Technologies

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

An employee's right middle finger was caught in a nip point. The employee suffered an amputation to the middle finger at the first knuckle.

An employee's left arm was caught in the fingers or jaws of the head stretcher machine, resulting in a laceration. The employee was hospitalized.

Two employees were setting up a mandrel in the spindle of a machine. The mandrel was side-shifted while an employee's hand was on the mast of a powered industrial truck. The employee suffered crushing injuries that resulted in amputations to the middle and ring fingertips.

An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.

An employee was positioning an overhead crane to stand up a skidded coil when the coil swung back. The employee was caught between the swinging coil and another coil sitting on a coil pad, resulting in hospitalization due to a loss of consciousness and a pelvic injury.

An employee was performing general cleanup duties when they collapsed and passed out due to heat exhaustion. They were hospitalized for heat exhaustion, dehydration, and acute renal failure.

A temporary employee was helping a forklift operator by holding metal sheets to steady them as they were placed on a rail for feeding to a stamp machine. The operator lowered the forks with the blanks (weighting approximately 750 pounds). The temporary employee's right index finger was caught between the metal and the feeding rail. The finger was crushed and partially amputated through the bone.

An employee was using a mechanical trim press to trim flash off metal parts. The employee was loading a part to be trimmed when the press cycled and crushed the index fingers on both of their hands. The employee sustained a fingertip amputation. The machine was not guarded at the time.

An employee was adjusting a metal coil on a press when his left hand became caught between the arm of the coil holder and the coil. Their thumb was cut and partially amputated.

An employee was closing a door when the door closed on their right index finger, resulting in a fingertip amputation.

An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.

An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.

An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.

An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.