OSHA Inspection: FAURECIA EMISSIONS CONTROL SYSTEMS NA, LLC

Issued

2022-01-10 00:00:00

Abate by

2022-02-28 00:00:00

Penalty

Initial $13653.00 · Current $4100.00 Reduced

General-duty citation text

1910.147(c)(4)(ii)(B)  Specific procedural steps for shutting down, isolating, blocking and securing machines or equipment to control hazardous energy;   a) On or about September 21, 2021, Employees who performed servicing and maintenance such as but not limited to die changes on the Finishing Machine S550, powered by electrical, hydraulic, and pneumatic energy, were not required to:  (1) Preparation for shutdown. Before an authorized or affected employee turns off a machine or equipment, the authorized employee shall have knowledge of the type and magnitude of the energy, the hazards of the energy to be controlled, and the method or means to control the energy.  (2) Machine or equipment shutdown. The machine or equipment shall be turned off or shut down using the procedures established for the machine or equipment. An orderly shutdown must be utilized to avoid any additional or increased hazard(s) to employees as a result of the equipment stoppage.  (3) Machine or equipment isolation. All energy isolating devices that are needed to control the energy to the machine or equipment shall be physically located and operated in such a manner as to isolate the machine or equipment from the energy source(s).  (4)(ii) Lockout or tagout device application. Lockout devices, where used, shall be affixed in a manner to that will hold the energy isolating devices in a "safe" or "off" position  (5)(i) Stored energy. Following the application of lockout or tagout devices to energy isolating devices, all potentially hazardous stored or residual energy shall be relieved, disconnected, restrained, and otherwise rendered safe.