National Steel City

An employee was moving steel beams when his finger was pinched and lacerated between two of them. He was wearing cut-resistant gloves.

An employee was assisting with pipe on a drilling rig. The slips came down and landed on the employee's left foot fracturing four metatarsals.

Two employees were struck by the rotary table of a drilling rig while installing caisson. Employee 1 suffered multiple fractures, internal injuries, and head trauma. Employee 2 suffered multiple fractures, internal injuries, spinal injury, and head trauma.

Employees were felling hazard trees. The injured employee was conducting 'bucking' operations to saw a tree from the road when the tree kicked-back, pinning him against the ground and fracturing his left femur. The employee was hospitalized and required surgery.

An employee was greasing tongs on a work-over rig. The tongs lacerated one of the employee's fingers.

An employee was chaining a vehicle when he had to change tools and the compressor. As the compressor was being charged, the employee stepped near the vehicle to make sure the compressor was attached. Then, he instructed a co-worker to lower the compressor. His right hand was on the compressor and under the chain, causing his ring finger to be crushed.

An employee was rolling a pipe in a cutting rack and his right little finger became caught between sections of the pipe. The employee's finger was surgically amputated.

An employee was working a vertical bandsaw, cutting half-inch diameter rods into pieces. While using a steel chisel to move the cut pieces, the blade caught his leather glove and pulled his index finger in. The employee sustained an amputation of the finger between the first and second knuckle.

An employee was operating a lathe in a machine shop. The rotating head of the lathe caught the employee's left glove, resulting in a compound open fracture to the left wrist and a laceration to left ear.

An employee was descending the stairs of an oil/gas rig. As he approached the fifth step from the bottom, he slipped. His left ankle was caught in the steps, and he suffered fractures to the left fibula, tibia, and talus. He was hospitalized, requiring surgery.

The injured employee was loading a piece of pipe into a pipe bending machine. He had his right hand on the front of the loader while his left hand supported the piece of pipe in the back. A second operator had slightly clamped around the pipe to keep it in place. The third operator called out a measurement. The machine actuated and caught the the injured employee's left middle and ring fingers between the wiper and the material. The employee required surgery and sustained amputations to the distal joint of the middle and ring fingers.

An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.

A casting machine jammed. An employee's hand was caught in the machine, where a belt line caught and amputated the tip of his finger.

During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.

An employee slipped on condensation on a walkway in a parking garage. She fell and suffered a closed fracture to the neck of the left femur.

An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.