Nonroadway collision with object other than vehicle, n.e.c. · Soreness, pain, hurt-nonspecified injury
At a glance
Federal OSHA recorded a severe workplace injury
at WORLDWIDE FLIGHT SERVICES, 2299 Airport Road, WICHITA, KANSAS 67209
on — Soreness, pain, hurt-nonspecified injury, affecting the knee(s).
Final narrative
Employee was out on the ramp while driving a tug. He hit a curb and was ejected from the tug. The tug ran over both of his knees, injuring him. He was going to get some baggage from the carousel to load into the airplane. During this process, he hit the curb and got injured.
An employee was offloading an airplane flight. After driving a transporter car to place a pallet on a static rack, he got off the transporter to apply the lock and secure the pallet on the rack. The pallet began to roll off the rack and pinned the employee against the transporter. He suffered a broken right leg.
At about 3:45 a.m. on June 13, 2025, an employee was hooking up dollies before an aircraft landed. His right middle finger was pinched between a dolly tongue and a hitch connector, and he suffered a partial amputation to the fingertip. The employee was hospitalized and required surgery.
An employee was removing unit load device (ULD) containers from a slave dolly. A forklift reversed and struck the employee, resulting in a fractured ankle.
An employee was driving a truck. He turned the truck onto an uneven surface when a strong wind caused the vehicle to overturn. The employee suffered four broken ribs and an abdominal injury.
An employee was transferring cargo/freight from a K-loader onto a dolly. The pallet rolled to the opposite end of the dolly where the employee was standing and fell on him. He was crushed between a catering truck and the pallet and sustained chest injuries.
An employee was driving a cart around the driving range to pick up golf balls. The vehicle struck an in-ground target causing the employee to strike his forehead on the windshield. The employee was hospitalized with fractures to their nose and cheekbone and lacerations to their head and hands.
An employee was operating a picker when it struck a stack of pallets. His body moved forward and he struck his face on the computer monitor in the vehicle, resulting in a concussion, laceration, and blurry vision.
An employee was driving a lift in reverse through an aisle while the lift was loaded with a headboard. The headboard caught merchandise in the aisle racks, causing it to shift and contact the employee's right leg. The employee suffered a broken leg.
An employee was driving a utility task vehicle (UTV) through the parking lot to the boat yard to meet a co-worker. The UTV and slid into a curb, causing it to flip on its side and land on the employee's leg, resulting in a broken leg.
On December 7, 2023, an employee was driving an order picker down an aisle when the mast of the vehicle struck a material pan that was hanging out of the rack. The pan fell and struck the employee, resulting in rib fractures and a spleen laceration.
More severe injuries in this industry (NAICS 488119)
An employee was operating a tug that had been re-tagged due to faulty brakes. As the employee approached the designated parking area, he slowed the tug using the clutch and then exited the tug. He went to stop the tug from colliding with a concrete wall when his right ankle became caught between the tug and a parking stall barrier. He sustained a fractured ankle and was hospitalized.
An employee had just arrived to work and was driving a tug to the gatehouse. The tug ran over chocks while exiting the inbound area, causing the employee to fall to the ground. He was hospitalized with four fractured ribs.
An employee was manually pulling a container from the aft cargo hold of a wide-body jetliner. Their right little finger got pinned between the container and the edge of the cargo door. The employee's finger was partially amputated.
An employee was offloading an airplane flight. After driving a transporter car to place a pallet on a static rack, he got off the transporter to apply the lock and secure the pallet on the rack. The pallet began to roll off the rack and pinned the employee against the transporter. He suffered a broken right leg.
An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.
An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.
An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.