Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Worthington Cylinders, 795 Sam Barkley Drive, NEW ALBANY, MISSISSIPPI 38652
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
Employee reached into the press #78 and his left index finger was severed at the second joint. The press has a pop up release which is activated after the cycle, the employee placed his hand while the pop up release was in operation catching the employee's hand between the part and the top of the press.
An employee was performing maintenance on a cold header machine in the MVH. He was lining up a pin hole to put a one-inch round pin between the arm of the cold header machine and a piece of metal. The arm slipped out of his hand and dropped causing a partial amputation to the employee's left index finger.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 332420)
An employee was standing on a 10-inch high working platform (36.75"x24"x10") verifying that tanks were being picked up properly by an overhead conveyor. The employee turned and was stepping off the platform when their left work boot caught the edge of the platform. The employee fell to the concrete floor and landed on their right side. The employee's right hip was fractured.
An employee was working on a vessel, attaching the base plate ring to the legs, when the base plate shifted about 3 inches. The employee's right foot became pinned between the base plate and the floor. Three toes were crushed. The employee was hospitalized and required surgery, resulting in partial amputation of their toe tips.
Two employees were constructing a 30-foot-tall aboveground storage tank, fitting a double roof on the tank. Half of the roof had been stitch-welded to the tank, and the employees were fitting/tacking down the second half of the roof, when the roof shifted and fell in. One employee fell and sustained fractures to their right foot and shin. The second employee suffered a broken back. Both employees required hospitalization.
Two employees engaged in a verbal altercation. The injured employee was punched in the face and fell, hitting their head on the concrete floor. The employee sustained a brain bleed and blunt force trauma to the face.
An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.
The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.
An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.
An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.
An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.