Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Parker-Hannifin Corporation, 1501 Hayes Dr., MANHATTAN, KANSAS 66502
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was polishing a shaft on a lathe with an emry cloth when his hand became caught, pulling him into the lathe and injuring his right hand. He fractured the ring and pinky fingers on his right hand and sustained damage to the flesh as well. His right pinky finger was amputated due to the damage.
An employee was cutting extruded aluminum framing material using a horizontal band saw. She went to grab a rag in the machine when the rag contacted the blade and pulled her hand in toward the blade, resulting in a partial amputation of the right index finger.
An employee was repositioning a limiter inside an assembly fixture. The employee's fingertip was pinched between the fixture and the limiter, causing a partial fingertip amputation.
An employee was performing maintenance activities on a ladder when they fell approximately 46 inches to the ground, resulting in a fracture to the left pelvis/sacrum.
An employee was aligning bar stock in the collet of a CNC machine and troubleshooting. As the employee was making an adjustment in the collet cage, the machine was activated, causing the collet to move forward and pinch the employee's hand. A finger and the thumb on the hand were medically amputated.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 326220)
An employee was preparing to cut rubber stock on a pneumatic cutting machine when their middle and ring fingertips were amputated by the cutting blade.
At about 12:25 a.m. on September 3, 2025, an employee was troubleshooting a malfunction involving a slitter whose arbor was not rotating as expected. The employee was observing the slitter's operations when the arbor completed its cycle and the employee's right index finger was drawn into the slitter's 4-inch, non-rotating cutting blade. The fingertip was amputated.
An employee was operating a rolling rope machine. Tooling fell out of the machine and landed on the employee's foot, breaking bones. The machine was not guarded at the time.
An employee was operating a machine when hot air and water was released. The employee sustained burns to the neck, back, buttocks and leg on the right side.
An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.
An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.
An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.