HOUSTON, TEXAS—
Gulf Stream Marine
Compressed or pinched by shifting objects or equipment · Avulsions, enucleations
At a glance
Federal OSHA recorded a severe workplace injury at Gulf Stream Marine, 10000 Manchester Avenue, HOUSTON, TEXAS 77012 on — Avulsions, enucleations, affecting the fingertip(s).
Final narrative
At approximately 11:00 a.m., employees were working at Manchester Terminal onboard a vessel. Approximately 12 employees were loading 5' x 10' steel plates onto the vessel (BBC Plata). The ship's crane was loading the plates inside the vessel with assistance from the employees. During the operation, two of the injured employee's fingers got pinched between two plates. He pulled away, and his left-hand, middle ring fingertip was partially severed (degloving).
More severe injuries at Gulf Stream Marine
BROWNSVILLE, TEXAS—
Gulf Stream Marine
An employee was working inside the cargo hold of a cargo ship, discharging steel slabs. The slabs (approximately 4 feet by 20 feet) were being hoisted by a powered industrial truck (PIT) equipped with an electromagnetic lifting device. The lifting device failed and released a steel slab that struck the employee's right foot. The employee sustained injuries to their big toe, including partial amputation.
HOUSTON, TEXAS—
Gulf Stream Marine
An employee was reaching over a small stack of steel billets on the ground to cut a strap. When the strap was cut, one of the billets (weighing 5,182 pounds) rolled down onto his right leg. He was pinned and suffered a broken tibia. The incident occurred while the employee was training.
HOUSTON, TEXAS—
Gulf Stream Marine
An employee was working near a 36,000-pound powered industrial truck when they were struck by its tire. The employee was hospitalized for bilateral ankle fractures.
HOUSTON, TEXAS—
GULF STREAM MARINE
An employee was working inside a gondola rail car, rigging bundles of steel rebar for hoisting out of the car. During a partial breakout lift (hoisting about 2 feet to gain access for slinging), a nylon strap parted under the 1,100-2,200-pound load, which fell back into the car and struck the employee. The employee suffered a broken femur and collarbone.
HOUSTON, TEXAS—
Gulf Stream Marine
While on a ship, an employee was lifting one side of a pipe and putting a strap underneath it. As the employee was about to break out, one end of the pipe joints slipped out, allowing the pipe (6"/40') to roll and strike the employee's lower left leg. The employee's leg was fractured above the ankle, requiring hospitalization and surgery.
View Gulf Stream Marine's full OSHA safety record →
Similar incidents · Same event type
MECHANICSBURG, PENNSYLVANIA—
TForce Freight
An employee was operating a forklift and unloading a truck. After the truck was unloaded, the employee got off the forklift and proceeded to adjust the dock plate with a hook tool. The dock plate slipped and the employee went to adjust the plate with their hand when their left middle finger got caught. Their finger was amputated above the first joint.
DELAWARE CITY, DELAWARE—
Liveo Research, Inc.
An employee was rotating a carbide granulator blade when his finger was caught between the blade and a stationary part of the machine. The employee's right middle finger was partially amputated and they suffered an avulsion to the right ring fingertip.
FORT WORTH, TEXAS—
Best Pump and Flow
An employee was using a CNC metal lathe machine in manual mode to check that the thread blocking tool made contact with the jaws. As the employee was manually spinning the spindle, his index fingertip was crushed between the spindle's jaws and the grooving insert, resulting in a fingertip amputation.
BUFFALO, NEW YORK—
FORD MOTOR COMPANY
During a material handling operation, an employee's fingertip was caught under an air conditioning unit as the unit was lowered onto a cart. The employee's fingertip was amputated.
UNADILLA, GEORGIA—
Lasseter Tractor Company. Inc.
An employee was removing a bolt from a tractor hub when their right index finger was caught between the hub and the frame. The employee's fingertip was crushed and the employee was hospitalized.
More severe injuries in this industry (NAICS 488320)
HOUSTON, TEXAS—
Pathfinder Services LLC
While preparing to install a new spool piece for a vapor and spent sulfuric acid line, an employee was working to ensure there was no residual product or pressure in the line before removing the 6-inch hose. The valve was cracked, and some spent acid still in the line sprayed out. The employee was standing off to the side and at a distance, but was still contacted by the hot acid, resulting in corrosive and thermal burns to their upper torso and mid-thighs of both legs.
NORFOLK, VIRGINIA—
Virginia International Gateway Terminals, LLC
An employee was driving a utility tractor rig when it struck the rear trailer of another utility tractor rig, which was traveling in the opposite direction. The glancing impact caused damage to the cab, and he sustained a laceration on right side of his face, a cervical fracture, two fractured left ribs, and a pelvic fracture. The employee was hospitalized.
JOHNS ISLAND, SOUTH CAROLINA—
AHTNA Marine & Construction
The injured employee was standing by the controls for the electric spud system on the barge, preparing to raise the spuds. Meanwhile, an excavator was moving a mat on the deck. As the excavator swung from port to starboard, it's counterweight struck the injured employee s shoulder, causing them to lose balance and fall against the spud controls. The employee sustained bruises and contusions to their right shoulder and chest.
NEWBURGH, INDIANA—
Evansville Marine Service Inc
An employee was standing on the outside edge of a hopper barge while watching a skid steer push ore for an excavator (with a clamshell bucket) to unload. The excavator was on a work barge. The bucket of the excavator struck the employee and caused a near-amputation of their right arm and fractures of the ulna and radius of the left arm. The right arm required surgery.
NEW MARTINSVILLE, WEST VIRGINIA—
WATCO Transloading, LLC
An employee was inspecting a conveyor to see why it was not running. The employee entered the the conveyor motor area, tripped on a piece of angle iron welded to the floor, and fell. The employee sustained a fractured orbital bone.
More severe injuries in TEXAS
EAST BERNARD, TEXAS—
T G Meat Center LLC
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
LUBBOCK, TEXAS—
Professional Flooring Supply
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
HOOKS, TEXAS—
EnviroSafe Demil LLC
An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.
LOLITA, TEXAS—
Inteplast Group
An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.
HALLETTSVILLE, TEXAS—
Regency IHS of Fairwinds Halletsville, LLC
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.