HOUSTON, TEXAS—
Gulf Stream Marine
Water vehicle incident, n.e.c. · Fractures
At a glance
Federal OSHA recorded a severe workplace injury at Gulf Stream Marine, 10000 Manchester Ave, HOUSTON, TEXAS 77015 on — Fractures, affecting the lower leg(s).
Final narrative
While on a ship, an employee was lifting one side of a pipe and putting a strap underneath it. As the employee was about to break out, one end of the pipe joints slipped out, allowing the pipe (6"/40') to roll and strike the employee's lower left leg. The employee's leg was fractured above the ankle, requiring hospitalization and surgery.
More severe injuries at Gulf Stream Marine
BROWNSVILLE, TEXAS—
Gulf Stream Marine
An employee was working inside the cargo hold of a cargo ship, discharging steel slabs. The slabs (approximately 4 feet by 20 feet) were being hoisted by a powered industrial truck (PIT) equipped with an electromagnetic lifting device. The lifting device failed and released a steel slab that struck the employee's right foot. The employee sustained injuries to their big toe, including partial amputation.
HOUSTON, TEXAS—
Gulf Stream Marine
An employee was reaching over a small stack of steel billets on the ground to cut a strap. When the strap was cut, one of the billets (weighing 5,182 pounds) rolled down onto his right leg. He was pinned and suffered a broken tibia. The incident occurred while the employee was training.
HOUSTON, TEXAS—
Gulf Stream Marine
An employee was working near a 36,000-pound powered industrial truck when they were struck by its tire. The employee was hospitalized for bilateral ankle fractures.
HOUSTON, TEXAS—
GULF STREAM MARINE
An employee was working inside a gondola rail car, rigging bundles of steel rebar for hoisting out of the car. During a partial breakout lift (hoisting about 2 feet to gain access for slinging), a nylon strap parted under the 1,100-2,200-pound load, which fell back into the car and struck the employee. The employee suffered a broken femur and collarbone.
HOUSTON, TEXAS—
Gulf Stream Marine
At approximately 11:00 a.m., employees were working at Manchester Terminal onboard a vessel. Approximately 12 employees were loading 5' x 10' steel plates onto the vessel (BBC Plata). The ship's crane was loading the plates inside the vessel with assistance from the employees. During the operation, two of the injured employee's fingers got pinched between two plates. He pulled away, and his left-hand, middle ring fingertip was partially severed (degloving).
View Gulf Stream Marine's full OSHA safety record →
Similar incidents · Same event type
POINT HOPE, ALASKA—
Boyer Towing INC.
An employee was assisting with loading product (sacks of dirt) onto a barge. The sack of dirt swung and pinched the employee between it and other sets of product on the barge. The employee suffered a neck compression injury and was knocked unconscious.
SCOTT DEPOT, WEST VIRGINIA—
Brayman Construction & Trumbull, A Joint Venture
An employee was on a barge adjacent to a lift that was being tested. As the load was lowered, a nylon stiffener broke free from existing structural steel and fell 80 feet, striking the employee in the right forearm. The employee sustained two broken bones in the forearm.
AVONDALE, LOUISIANA—
Host Terminals LLC
An employee was offloading cargo from the hatch of a motor vessel onto a dock when the cargo (bagged cement) struck the employee and caused them to contact a nearby hatch wall. The employee sustained injuries to their neck, right lower back and right leg.
CEREDO, WEST VIRGINIA—
Kanawha River Terminal
An employee was walking across the barge when they stepped across a barge gunnel lid that was hidden due to coal spillage. The lid came up and struck the employee, resulting in abdominal bruising.
SAN DIEGO, CALIFORNIA—
BAE Systems San Diego Ship Repair Inc.
An employee was climbing up an A-frame ladder to gain overhead access to install ship ventilation equipment. The employee's safety glasses bumped the sprinkler head diffuser, which knocked his glasses off and caused a laceration to his left lower eyelid and an injury to the sclera.
More severe injuries in this industry (NAICS 488320)
HOUSTON, TEXAS—
Pathfinder Services LLC
While preparing to install a new spool piece for a vapor and spent sulfuric acid line, an employee was working to ensure there was no residual product or pressure in the line before removing the 6-inch hose. The valve was cracked, and some spent acid still in the line sprayed out. The employee was standing off to the side and at a distance, but was still contacted by the hot acid, resulting in corrosive and thermal burns to their upper torso and mid-thighs of both legs.
NORFOLK, VIRGINIA—
Virginia International Gateway Terminals, LLC
An employee was driving a utility tractor rig when it struck the rear trailer of another utility tractor rig, which was traveling in the opposite direction. The glancing impact caused damage to the cab, and he sustained a laceration on right side of his face, a cervical fracture, two fractured left ribs, and a pelvic fracture. The employee was hospitalized.
JOHNS ISLAND, SOUTH CAROLINA—
AHTNA Marine & Construction
The injured employee was standing by the controls for the electric spud system on the barge, preparing to raise the spuds. Meanwhile, an excavator was moving a mat on the deck. As the excavator swung from port to starboard, it's counterweight struck the injured employee s shoulder, causing them to lose balance and fall against the spud controls. The employee sustained bruises and contusions to their right shoulder and chest.
NEWBURGH, INDIANA—
Evansville Marine Service Inc
An employee was standing on the outside edge of a hopper barge while watching a skid steer push ore for an excavator (with a clamshell bucket) to unload. The excavator was on a work barge. The bucket of the excavator struck the employee and caused a near-amputation of their right arm and fractures of the ulna and radius of the left arm. The right arm required surgery.
NEW MARTINSVILLE, WEST VIRGINIA—
WATCO Transloading, LLC
An employee was inspecting a conveyor to see why it was not running. The employee entered the the conveyor motor area, tripped on a piece of angle iron welded to the floor, and fell. The employee sustained a fractured orbital bone.
More severe injuries in TEXAS
EAST BERNARD, TEXAS—
T G Meat Center LLC
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
LUBBOCK, TEXAS—
Professional Flooring Supply
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
HOOKS, TEXAS—
EnviroSafe Demil LLC
An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.
LOLITA, TEXAS—
Inteplast Group
An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.
HALLETTSVILLE, TEXAS—
Regency IHS of Fairwinds Halletsville, LLC
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.