Caught in running equipment or machinery during maintenance, cleaning · Soreness, pain, hurt-nonspecified injury
At a glance
Federal OSHA recorded a severe workplace injury
at Goodyear Dunlop Tires North America, Ltd. , 10 Sheridan Drive, TONAWANDA, NEW YORK 14150
on — Soreness, pain, hurt-nonspecified injury, affecting the wrist(s).
Final narrative
An employee had just adjusted a nut on the motorcycle tire-building machine he was servicing. He instructed the operator to put the machine into auto mode. When the employee's hand entered the machine, the beadset (a movable part on the machine) moved forward, and his wrist got caught in a crush point between the beadset and the drum.
HospitalizedWrist(s)Special process machinery, n.e.c.
More severe injuries at Goodyear Dunlop Tires North America, Ltd.
An employee had just retrieved a full 30 lb. propane tank from storage and was walking and carrying the tank to place it on a forklift truck. The employee slipped on ice and fell breaking his fibula and tibia bones.
Two employees were repairing the hydraulic engagement pins on a rented front-end wheel loader. The machine controls were activated to move the attachment pins and an employee's finger was caught between the pins and the bushings. Their right index finger was partially amputated.
An employee was cleaning the conveyor on a piece of equipment when they slipped and their right hand was pulled into the chain sprocket. The employee's fifth fingertip was amputated.
An employee was throwing blankets onto a blanket folding and stacking machine. A blanket got stuck in the machine and she attempted to remove it when the machine contacted her right little finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 326211)
On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.
An employee was adjusting a pallet on a conveyor when it came off the conveyor and struck his right ankle, breaking the tibia and fibula. The employee was hospitalized.
At 2:45 p.m., an employee was outside the plant during a break before his next shift. He was speaking with an associate when he suddenly fell from the third-level steps to the ground, striking his head on the concrete. The employee was hospitalized due to internal brain bleeding, a wound to the back of his head requiring staples, and heat-related dehydration.
Two employees were replacing a motor on an overhead conveyor. The old motor fell to the floor, causing a piece of the concrete floor to fly up and strike the injured employee in the face, around the eye. The injured employee sustained a right orbital fracture, a zygomatic arch fracture, and a sphenoid fracture. The employee was hospitalized and required surgery.
An employee was changing the bladder on a hydraulic press. As he lowered the bladder, his left foot was pinned between its bottom ring and the bottom mold of the press. The second toe on the foot was amputated.
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.
An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.