Caught in running equipment or machinery, n.e.c. · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at TRINIDAD DRILLING, 5.7 Miles East FM 3445 and Hwy 16 , PLEASANTON, TEXAS 78064
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was attempting to place the pipe spinner leaver in neutral position when he tripped. His right hand engaged the spinner, and his left hand got caught in the spinner chain, cutting his left pinky and ring fingers.
HospitalizedAmputationFinger(s), fingernail(s), n.e.c.Oil drilling rigs and machinery
Employees were assembling and testing a butterfly valve unit and actuator combo. When the unit was function tested with air, the valve gate closed on an employee's left thumb resulting in a fracture and laceration.
An employee was doing a daily inspection of the sifter screen on a mixer when the mixer line activated. The armature for the screen struck the employee's right wrist. Their wrist was cut and their hand was fractured.
An employee was doing a dry run during the setup of an ice cream machine. The machine indexed and the filler head amputated the employee's left middle finger above the last knuckle.
An employee was on a 3-foot ladder guiding cable onto a spool during installation on an overhead door. As the control box was jogged, the employee's hand was caught between the cable and spool, resulting in a wrist and hand fracture.
More severe injuries in this industry (NAICS 211111)
An employee was slipping pipe when it became stuck and the pipe snapped, striking the employee in the back and ribs. The employee sustained fractured ribs.
An employee was standing on an injector head feeding chain with a rope, when the rope broke, causing him to lose his balance and fall to the ground. The employee sustained fractures to his left elbow and three ribs.
An employee was pulling drill line from the drill spool while the top drive was not set on the docking pins. The deadman was unexpectedly released which caused the top drive to fall to the drill floor from a height of 30 feet. This caused the drill line that was being pulled out and laid on the ground to retract and strike an employee. The employee suffered fractures to his legs and neck.
An employee was conducting maintenance on a pipe and was using a T-bar tool to secure the retainer cap on a pump. The employee's left index finger was caught in the rotating pump, resulting in a partial amputation.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.