Orion Marine Construction, Inc.

An employee was rigging a portable welding machine to the lifting hook of an excavator. Their right hand became caught between the excavator bucket and the welding machine. The employee sustained a laceration to their hand and a fracture/dislocation to their middle finger.

An employee was loosening bolts with a wrench. The wrench slipped and cut the employee's fingertip.

An employee amputated his right second and third fingertips with a rope.

An employee was operating a machine when a wire pulled his right glove resulting in amputation of the index and middle fingertips.

An employee was grinding chicken when their right index fingertip was caught in the grinder and amputated.

An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.

An employee was passing through a large metal door when the door closed on the employee, resulting in a cracked rib.

An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.

An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.

An employee fell while stepping off the tailgate of a pickup truck. The employee landed on the ground and suffered a broken left fibula and tibia.

On October 7, 2025, employees were conducting trenching operations for the installation of a new sewer line system. The excavator's bucket was detached and put inside the trench as it was being exchanged for a different-sized bucket. An employee entered the trench with a shovel to move some dirt located at the front end of the pipe. The excavator bucket shifted and slid, striking the employee s right foot and trapping it against the ground. The employee sustained a fractured right tibia.

Employees were working to dislodge a large truck that was stuck in a rut using tow straps and a front-end loader with the bucket removed. An employee connected the straps to the loader and truck and another employee slowly engaged the loader to close the coupler. The injured employee's arm became caught in a pinch point. The employee was hospitalized with a fractured arm.

An employee was lifting a piece of 30-inch line stopping equipment using a jack screw. A lifting eye weld snapped and the load dropped. The end of the jack screw then landed on the employee's heel and crushed it. The employee was hospitalized.

An employee delivered a package. On her way back to her vehicle she was attacked by two dogs that came from around a corner. She was hospitalized with dog bites.

The injured employee was standing by the controls for the electric spud system on the barge, preparing to raise the spuds. Meanwhile, an excavator was moving a mat on the deck. As the excavator swung from port to starboard, it's counterweight struck the injured employee s shoulder, causing them to lose balance and fall against the spud controls. The employee sustained bruises and contusions to their right shoulder and chest.

A technician was operating a crane hoist to lift/remove a cylinder head from the main engine (port). The load was lifted at an angle, causing the cylinder head to get stuck on the cylinder head studs. When it became free from the studs, the cylinder head swung. It struck the technician and caught them against the cabinet door. This resulted in an amputation of their left index fingertip at the distal knuckle.

An employee was securing a power cord to a refrigerated truck container. A truck started backing up to connect with the container and the employee was pinned between the tires of the container and the bolster of the truck, resulting in a fractured leg.

An employee was delivering a package to a house when a dog came through the storm door, jumped on the employee, and bit them in the lower jaw.