105,313Records 71,083Employers 85,290Hospitalizations 27,770Amputations 2015-01-01 2025-10-31
Safety Incidents OSHA Severe Injury Reports · 2015–2025

Fairbanks Morse, LLC

Struck by suspended or swinging objects n.e.c. · Amputations involving bone loss

Federal OSHA recorded a severe workplace injury at Fairbanks Morse, LLC, 1670 Dry Dock Ave #200, NORTH CHARLESTON, SOUTH CAROLINA 29410 on — Amputations involving bone loss, affecting the Finger or thumb tip(s), nail(s).

A technician was operating a crane hoist to lift/remove a cylinder head from the main engine (port). The load was lifted at an angle, causing the cylinder head to get stuck on the cylinder head studs. When it became free from the studs, the cylinder head swung. It struck the technician and caught them against the cabinet door. This resulted in an amputation of their left index fingertip at the distal knuckle.

Amputation Finger or thumb tip(s), nail(s) Combustion engine blocks, cylinders, pistons

Ardent Mills

An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.

Concrete Industries Nebraska City

An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.

Cives Steel Company New England

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

Hanna Steel Corporation

An employee was placing a board on top of a bundle of steel tubing. A crane was moving a bundle of steel that struck the employee and caught them against another bundle of steel tubing. The employee sustained a crushing injury and hematoma to the right upper leg.

Tri-State Tree Service LLC

Employees were using a crane to lower large tree stems and branches while removing limbs and branches from the load. This caused the load to shift and strike an employee in the back, resulting in a hematoma on the lower left part of their back and a fractured ankle.

TRC Services of Texas INC

An employee was sorting sucker rods. His right hand was caught in the area where the rod hits up against the frame and his index fingertip was amputated just below the nail.

Onpoint Industrial Services Hiring Center

An employee was using a powered miter saw to cut 2x4's. The saw blade hit something inside a board (possibly a hidden nail) and jumped, causing a laceration to the employee's left forearm. The employee was hospitalized with soft tissue and tendon injuries that required surgery.

S&R Compression, LLC

A crane had been used to set a steel plate on a steel frame. An employee was trying to remove a clamp from the plate when the plate fell and crushed the tip of his left little finger. The employee sustained a fingertip amputation.

Morgan Engineering Systems, Inc

An employee was operating a scissor lift, raised to a height of about 15 feet, to inspect an overhead crane rail. The crane itself was being moved. Its hook swung into the scissor lift s arms, causing the lift to tip over onto its side, which in turn caused the lift and the employee to fall to the floor. The employee suffered injuries including broken ribs, spinal fractures, scapula fractures, and internal injuries.

A&H Equipment Company

An employee was cutting a pallet down with a circular saw when the blade cut his left leg.

U.S. Postal Service

An employee delivered a package. On her way back to her vehicle she was attacked by two dogs that came from around a corner. She was hospitalized with dog bites.

AHTNA Marine & Construction

The injured employee was standing by the controls for the electric spud system on the barge, preparing to raise the spuds. Meanwhile, an excavator was moving a mat on the deck. As the excavator swung from port to starboard, it's counterweight struck the injured employee s shoulder, causing them to lose balance and fall against the spud controls. The employee sustained bruises and contusions to their right shoulder and chest.

Container Maintenance Corporation

An employee was securing a power cord to a refrigerated truck container. A truck started backing up to connect with the container and the employee was pinned between the tires of the container and the bolster of the truck, resulting in a fractured leg.

U.S. Postal Service

An employee was delivering a package to a house when a dog came through the storm door, jumped on the employee, and bit them in the lower jaw.

U.S. Dept of Air Force

An employee saw smoke coming from a room and entered to a pot of oil on a hot stove. As he carried the pot out of the room, oil splashed onto both his arms, resulting in second- and third-degree burns.