Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at BAE Systems, 4050 Peppers Ferry Rd., RADFORD, VIRGINIA 24141
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was operating a core pusher machine when her left index finger got caught between a hydraulic ram head and the machine itself, resulting in a partial finger amputation.
AmputationFinger(s), fingernail(s), n.e.c.Metal, woodworking, and special material machinery, unspecified
An employee was walking when his foot caught residual adhesive from floor tape and he tripped and fell to the concrete floor, resulting in a fractured right hip.
An employee was using a powered pallet jack to move a fixture. His leg became caught between the pallet jack and the fixture and he fell on the same level, resulting in a fractured left fibula.
The injured employee was trying to hold a door open for another employee when the automatic door closed on the injured employee's left ring finger. The employee's fingertip was amputated halfway down the fingernail.
An employee was inside a mid-level ballast tank onboard an amphibious transport dock (naval vessel). He was walking across the deck and stepped onto a board that was covering an open hole. The board split and the employee fell about 15 feet to the bottom of the tank. He sustained internal bleeding, a brain hematoma, and fractured the C6 and L1 vertebrae.
While adjusting the rigging for the bull gear installation, the bull gear became unstable and shifted. The shifting gear contacted the mobile platform on which the employee was standing knocking the platform over and causing the employee to fall to the ground. When the gear shifted, the employee's right index finger was caught between the rigging and the wood block resulting in amputation of the finger.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 332994)
An employee was clearing a firearm that had a jam in it. To disassemble the firearm, the employee was required to pull the trigger to remove the slide. During this process, the firearm discharged and the employee suffered a bullet wound to his left hand.
An employee was manually adding soda ash into a tank of heated water while on a mobile ladder. The fluid in the tank began to boil over the sides. The employee went to exit the mobile ladder to avoid the boiling liquid that was beginning to contact their lower legs. The employee lost balance and fell approximately 4 feet to the concrete below. The employee was hospitalized and had surgery for a dislocated left knee and thermal burns to the lower portion of both legs.
An employee was changing the bit on a horizontal gun drill. The wrench slipped while tightening a collet and the employee's left little finger was fractured and partially amputated.
A building engineer was inspecting a generator. As he closed the generator enclosure door, his right ring finger was caught between the door and the door frame. The fingertip was amputated.
An employee was walking back to a carrier case with mail in her hand when she tripped over a tub. Her back overarched as she fell, resulting in a fractured back that required hospitalization.
An employee was driving a utility tractor rig when it struck the rear trailer of another utility tractor rig, which was traveling in the opposite direction. The glancing impact caused damage to the cab, and he sustained a laceration on right side of his face, a cervical fracture, two fractured left ribs, and a pelvic fracture. The employee was hospitalized.
An employee was washing an aircraft from a scissor lift when they fell to the floor. The employee sustained a back injury and lacerations to their head and neck.