ANNISTON, ALABAMA—
BAE SYSTEMS
Struck by swinging or slipping object, other than handheld, n.e.c. · Amputations
At a glance
Federal OSHA recorded a severe workplace injury at BAE SYSTEMS, 2101 WEST TENTH STREET, ANNISTON, ALABAMA 36201 on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
While adjusting the rigging for the bull gear installation, the bull gear became unstable and shifted. The shifting gear contacted the mobile platform on which the employee was standing knocking the platform over and causing the employee to fall to the ground. When the gear shifted, the employee's right index finger was caught between the rigging and the wood block resulting in amputation of the finger.
More severe injuries at BAE SYSTEMS
YORK, PENNSYLVANIA—
BAE Systems
An employee was walking when his foot caught residual adhesive from floor tape and he tripped and fell to the concrete floor, resulting in a fractured right hip.
YORK, PENNSYLVANIA—
BAE Systems
An employee was using a powered pallet jack to move a fixture. His leg became caught between the pallet jack and the fixture and he fell on the same level, resulting in a fractured left fibula.
ANNISTON, ALABAMA—
BAE SYSTEMS
The injured employee was trying to hold a door open for another employee when the automatic door closed on the injured employee's left ring finger. The employee's fingertip was amputated halfway down the fingernail.
SAN DIEGO, CALIFORNIA—
BAE Systems
An employee was inside a mid-level ballast tank onboard an amphibious transport dock (naval vessel). He was walking across the deck and stepped onto a board that was covering an open hole. The board split and the employee fell about 15 feet to the bottom of the tank. He sustained internal bleeding, a brain hematoma, and fractured the C6 and L1 vertebrae.
FORT RILEY, KANSAS—
BAE Systems
An employee's sleeve became caught and tangled in a 3-inch magnet drill's bit, breaking the left arm in two places.
View BAE SYSTEMS's full OSHA safety record →
Similar incidents · Same event type
PORTAGE, WISCONSIN—
InterCon Construction, Inc.
A crew was pulling a 4-inch plastic gas pipe off a reel and straightening it for installation. The injured employee stepped up on the trailer to cut the last band holding the pipe in the coil on the reel. As he turned to step off the trailer, the end of the pipe rotated and sprung out of the cage surrounding the coil, striking the employee on the side of the head and knocking him off of the trailer into the roadway. The employee suffered head trauma that required hospitalization.
WYLIE, TEXAS—
RAVA Construction, LLC
An employee and a co-worker were performing a pick inside a clear well. They rigged the skid pan that was full of broken concrete. When lifting, the load began to swing toward a wall. The employee tried to stop the skid pan from swinging and was struck by the pan, resulting in fractures to their left hip and wrist.
MIDDLETOWN, OHIO—
Stein, LLC
The employee had just completed refueling a lattice crane that was breaking up material and was winding the fuel hose back into the fuel truck when he was struck by the catwalk/stairs of the crane. The employee was hospitalized with a laceration to his backside, possible internal bleeding, and a broken hip.
SELMA, TEXAS—
7 Site & Utility, LLC
An employee was fusing 10-inch black rubber utility pipes together using a pipe fusion machine and could not get the pipes to set correctly. The employee used a nylon strap attached to an excavator to lift one side of a pipe off a steel plate. As his hand was between two pipes, the pipes came back together, partially amputating two of his fingers.
STERLING, ILLINOIS—
Sterling Steel Company, LLC
An employee was lifting four bags of a lime blend weighing approximately 10,000 pounds using a crane. The load swung and pinned the employee against a structural I-beam, resulting in fractures to the hip and pelvis.
More severe injuries in this industry (NAICS 423510)
PITTSBURGH, PENNSYLVANIA—
Triad Metals International
A load of steel angles was being lowered when the lifting chain hit the load, causing it to slide toward an employee. An angle slid and pinched the employee, catching both of their legs between the beams and an angle. The employee suffered two fractured legs.
BEDFORD PARK, ILLINOIS—
Ryder System Inc.
An employee was on the deck of a trailer helping a customer unload tubes. The employee was working to place a cargo strap on the remaining tubes using a winch bar when it slipped off the tubing, causing him to lose his balance and fall headfirst onto the asphalt lot below. The employee suffered a contusion on his forehead, resulting in hospitalization.
SARASOTA, FLORIDA—
EASTERN METAL SUPPLY, INC.
An employee and a customer were unloading two rectangular tubes. The tubes were wrapped together. The plastic wrap was cut so that one tube could be picked up. As the employee was lifting the top tube, the other tube (still connected to the top tube) came down onto his hand and broke two of his fingers. He was hospitalized.
HOUSTON, TEXAS—
TEXAS PIPE AND SUPPLY COMPANY
An employee was assisting as a forklift got pipe from a pipe rack. The employee was on one of the forklift's forks as it was raised to the top of the rack, a height of about 15 feet. He fell to the ground and suffered a dislocated and fractured right elbow.
HAMILTON, OHIO—
United Performance Metals, LLC
On September 23, 2025, at approximately 7:43 p.m., an employee was using a knife to cut poly banding from a metal coil. The knife slipped, causing a laceration to the inside of their left arm at the elbow joint. The employee was hospitalized and required surgery to repair a damaged vein.
More severe injuries in ALABAMA
GENEVA, ALABAMA—
Sysco Gulf Coast, LLC
An employee was traveling down the maintenance aisle of a warehouse on a single-pallet front rider jack. The jack malfunctioned, causing the brakes to apply; the employee fell forward onto the concrete warehouse floor. The employee suffered an injury to the left leg and was hospitalized, requiring surgery.
BESSEMER, ALABAMA—
Norflex, Inc.
An employee was operating a metal roller machine to roll a small piece of metal. The employee's right index finger became caught between the metal and the machine, and the fingertip was amputated.
ANNISTON, ALABAMA—
Ampler Pizza II LLC
An employee was shot in the leg with a pistol during an altercation with two people who had entered the store without permission.
ATMORE, ALABAMA—
Birdsong Corporation
An employee was directing a truck driver to a dump site when the truck's peanut trailer slipped off the kingpin. As the trailer fell, a ladder attached to it lacerated the employee's ear. The employee was hospitalized.
ROGERSVILLE, ALABAMA—
Pilgrims
An employee was unloading a forklift from a trailer to the ground. The employee was climbing down the ladder of the trailer when their foot slipped through one of the rungs, causing them to fall backward onto the forklift forks. The employee was hospitalized for fractured ribs.