105,313Records 71,083Employers 85,290Hospitalizations 27,770Amputations 2015-01-01 2025-10-31
Safety Incidents OSHA Severe Injury Reports · 2015–2025

Young Electric, Inc.

Struck by falling object or equipment, unspecified · Soreness, pain, hurt-nonspecified injury

Federal OSHA recorded a severe workplace injury at Young Electric, Inc., 3046 E. 31 St. S., WICHITA, KANSAS 67216 on — Soreness, pain, hurt-nonspecified injury, affecting the multiple body parts, n.e.c..

Two employees were preparing two industrial control panels for shipment. The control panel is 5 feet wide, 7 feet tall, 1 foot deep, and weighs approximately 500lbs. They were setting one on the shipping pallet when the second one fell on top of the worker striking him on the back and injuring his right shoulder, ribs, and lung.

Hospitalized Multiple body parts, n.e.c. Switchboards, switches, fuses

Young Electric, Inc.

An employee had stepped into a company van to retrieve hardware/parts. As he was stepping backward out of the rear of the van, his pant leg snagged on the trailer hitch under the bumper. The employee fell backward out of the van, landing on his left hand and arm and sustaining fractures to the left distal radius and ulnar styloid.

View Young Electric, Inc.'s full OSHA safety record →

Amazon FTW5

An employee was unloading a trailer when a box fell and struck the employee in the face. The employee suffered a concussion and was hospitalized.

Tuff Shed, Inc.

An employee had been cutting lumber for a shed wall. A load of 16-foot trim pieces fell onto the employee causing vertebrae and ankle fractures.

Lufkin Industries

An employee was unloading 30-foot 2-inch barrels from a pan holding about 20 barrels. The barrels tipped over, striking and breaking both of the employee's lower legs.

Cy-Fair Coatings Inc

An employee was in a sandblasting area, preparing the surface of a plate heat exchanger frame for painting. The frame fell on the employee, who suffered fractures to vertebrae, the neck, pelvis, and rib cage; and punctured lungs.

Rodriguez General Carpentry

An employee was installing doors when one of the doors fell on him, fracturing his lower leg. The employee was hospitalized.

Smart Building Technologies - A Fidelity Company

An employee was troubleshooting the control setup for a variable air volume box above a ceiling. The employee's hand came into contact with an exposed, energized 277-volt wire that had loosened from its terminal on the box's assembly. He was shocked and fell off a ladder. His left hand passed across the ceiling grid and was lacerated. He also suffered an electrical burn to the right hand and was hospitalized.

Abbott Electric Inc

An employee was moving a scissor lift through a doorway. The employee was pinned between the scissor lift and the doorframe, sustained a back injury, and was hospitalized.

Mintcrest Corp

An employee was standing on an A-frame ladder approximately 6 feet above the floor while he attached a suspended light fixture to the ceiling. The employee lost balance, and fell to the tiled floor below, sustaining blunt force trauma to his head.

Cupertino Electric, Inc.

An employee was inspecting the overhead area of a single-person lift and repositioning the lift through a double doorway. As they were transitioning through the doorway, they were caught between the doorframe and the vertical mast of the lift. The employee was hospitalized with injuries to the nose, left maxillary sinus, left orbital bone, and left jaw, with fractures at the maxillary sinus area.

Swedberg Electric, LLC

The injured employee was performing routine maintenance on a fan belt/pulley. The injured employee and another person were moving the pulley back and forth manually to find a bearing issue. The injured employee's left ring finger got caught between the belt and the pulley wheel, resulting in a soft tissue amputation.

Omya Inc.

An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.

John Deere Coffeyville Works

An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.

Haven Steel Products Inc

An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.

Vestas-American Wind Tech

Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.

Alliance Ag and Grain LLC

An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.