Struck against moving part of machinery or equipment · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Cargill Malt, 3349 94th Avenue SE, SPIRITWOOD, NORTH DAKOTA 58481
on — Amputations, affecting the fingertip(s).
Final narrative
An employee sustained a right ring fingertip amputation when placing the right hand on the rail of moving equipment.
AmputationFingertip(s)Food and beverage processing machinery-specialized, unspecified
An employee was operating a strip saw. As the employee shut off the saw, their right index and middle fingertips were amputated by the blade before it came to a complete stop.
An employee was using a table saw to cut a piece of wood for wall framing. The wood jumped, causing the employee's hand to move toward the saw, amputating their left index finger and causing a laceration on their hand.
An employee was operating a trim saw. While trying to free a jammed board she had just cut, she came into contact with the running saw blade, which amputated her right thumb.
During a dust baghouse inspection, a discharge chute plugged up with grain debris. An employee went to remove the debris and his finger got caught in the rotary airlock. The employee sustained a laceration to their right middle finger that resulted in a partial amputation.
An employee was shutting down at the end of a shift when he noticed dust was jamming his machine. When the employee cleared the jam, his fingers made contact with the rotary airlock blade, resulting in the amputation of the middle finger right below the fingernail and the ring fingertip.
An employee was swapping barrels under a dust cyclone. The employee turned around and ran into an adjacent barrel and lost balance. His right hand went up the sock that surrounded the bottom of the dust collector and the rotating airlock blade partially amputated his index and middle fingers. The machine was not guarded at the time.
An employee was installing a new gear in a hand-operated flake mill and trying to line up the gear with a worm screw shaft approximately 18 inches long and weighing 30 pounds. The employee's left thumb was pinched between the shaft and the gear, resulting in a fingertip amputation.
An employee was entering an area through an opening in a plastic curtain barricade. The employee's foot got caught on the bottom of the curtain and she fell to the concrete floor, breaking both wrists.
An employee was on the ground working to close a trailer door. The door was caught by the wind and blew the employee backward. He landed on his back and sustained four fractured ribs, requiring hospitalization.
An employee was walking on top of boiler to close a valve. The employee fell off the boiler and landed on the floor, sustaining fractured ribs. The employee was hospitalized.
An employee was exiting a loader and coming down the ladder. His hand slipped off the railing and he fell backward onto sandy ground, landing on his side. The employee was hospitalized with a fractured pelvis and a rotator cuff tear.