Jack-knifed or overturned, nonroadway · Soreness, pain, hurt-nonspecified injury
At a glance
Federal OSHA recorded a severe workplace injury
at River Birch, LLC, 2000 South Kenner Rd, AVONDALE, LOUISIANA 70094
on — Soreness, pain, hurt-nonspecified injury, affecting the multiple body parts, n.e.c..
Final narrative
On May 1, 2015 at approximately 11:00 AM two employees were riding in an off-road ATV along the Lechate levee pond when the driver hit a rut and lost control of the vehicle. This caused the vehicle to slide and flip, ejecting the driver into the path of the roll over. The driver sustained injuries to his jaw, collarbone, ribs and internal bruising to his liver. The passenger was not injured.
HospitalizedMultiple body parts, n.e.c.ATV, all terrain vehicle
An employee was operating a sit-down type of material handling equipment (MHE). They were turning the MHE with the clamp attachment in the air when the MHE fell over onto its right side. The employee's right foot was caught under the battery cover of the MHE. The employee sustained a chemical burn from the battery and a fractured right ankle.
An employee was driving an unloaded forklift outside a building. During a left turn, the forklift drove off the paved area onto an unpaved surface, became unstable, and tipped over. The employee was pinned under the forklift and suffered two broken leg bones and a broken hip.
An employee was trimming tree branches from an aerial lift. As they were maneuvering the aerial bucket lift from inside, the truck drove over soft ground and tipped over. The bucket lift fell to the ground with the employee tied off inside, resulting in rib fractures.
More severe injuries in this industry (NAICS 562212)
A driver had backed up a rear load truck to a dumpster. The winch cable was bound, and another employee went to use the controls to put slack in the line. The cable tightened instead of loosening while the driver was holding it, and it caught his hand against the truck and crushed his thumb. The thumb was fractured and lacerated; he was hospitalized, requiring surgery. The incident took place during a training activity.
An employee was pulling into a customer's parking lot to pick up a roll-off container when the vehicle ran over the median curb. The vehicle then veered to the left, striking the side curb and the retaining wall. The employee sustained injuries to his neck and spine, as well as a damaged artery, a head laceration, and fractured ribs.
An employee was replacing the bracing arm of a baler. The replacement part (weighing an estimated 500 pounds) was moved into place using a truck-mounted crane with a lifting strap attached to the designated pick point. The employee then used his right hand to stabilize/align the part. The part shifted, crushing his right index finger against the mounting pin hole. The employee's finger was amputated above the first knuckle.
An employee was moving a mower with a tractor bucket when the bucket slipped and struck another employee on the hand. The injured employee sustained a partial amputation of their left little finger.
A driver was exiting his vehicle outside the plant gate when his foot slipped on the top step of the truck. He fell to the ground, landed on his left hip and elbow. The employee was hospitalized with a fractured hip/femur.
A security employee was responding to an urgent call from staff regarding a violent patient. The employee tripped and fell on the floor outside of the stairwell. The employee sustained a closed head injury, contusion of the cerebrum without loss of consciousness, and a closed fracture of the distal end of the right radius.
A temporary employee was testing an electrical starter motor. He was placing tape on the starter while the breaker was not engaged, but the starter sent an arc flash that burned his hands and stomach.
An employee was walking on a sidewalk and stubbed his toe on an elevated portion of concrete, causing him to trip and fall. The employee's right knee was dislocated.